diff mbox series

[ath-next] wifi: ath12k: Fix incorrect rates sent to firmware

Message ID 20250318085013.1296262-1-quic_rdevanat@quicinc.com
State Superseded
Headers show
Series [ath-next] wifi: ath12k: Fix incorrect rates sent to firmware | expand

Commit Message

Roopni Devanathan March 18, 2025, 8:50 a.m. UTC 
From: Pradeep Kumar Chitrapu <quic_pradeepc@quicinc.com>

Before firmware assert, if there is a station interface in the device
which is not associated with an AP, the basic rates are set to zero.
Following this, during firmware recovery, when basic rates are zero,
ath12k driver is sending invalid rate codes, which are negative values,
to firmware. This results in firmware assert.

Fix this by checking if rate codes are valid, before sending them
to the firmware.

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1

Signed-off-by: Pradeep Kumar Chitrapu <quic_pradeepc@quicinc.com>
Signed-off-by: Roopni Devanathan <quic_rdevanat@quicinc.com>
---
 drivers/net/wireless/ath/ath12k/mac.c | 13 +++++++++----
 1 file changed, 9 insertions(+), 4 deletions(-)


base-commit: b6f473c96421b8b451a8df8ccb620bcd71d4b3f4
diff mbox series

Patch

diff --git a/drivers/net/wireless/ath/ath12k/mac.c b/drivers/net/wireless/ath/ath12k/mac.c
index 9fda97667d4e..3b6ee1e65f1b 100644
--- a/drivers/net/wireless/ath/ath12k/mac.c
+++ b/drivers/net/wireless/ath/ath12k/mac.c
@@ -3450,7 +3450,9 @@  static void ath12k_recalculate_mgmt_rate(struct ath12k *ar,
 	}
 
 	sband = hw->wiphy->bands[def->chan->band];
-	basic_rate_idx = ffs(bss_conf->basic_rates) - 1;
+	basic_rate_idx = ffs(bss_conf->basic_rates);
+	if (basic_rate_idx)
+		basic_rate_idx -= 1;
 	bitrate = sband->bitrates[basic_rate_idx].bitrate;
 
 	hw_rate_code = ath12k_mac_get_rate_hw_value(bitrate);
@@ -3983,10 +3985,13 @@  static void ath12k_mac_bss_info_changed(struct ath12k *ar,
 		band = def.chan->band;
 		mcast_rate = info->mcast_rate[band];
 
-		if (mcast_rate > 0)
+		if (mcast_rate > 0) {
 			rateidx = mcast_rate - 1;
-		else
-			rateidx = ffs(info->basic_rates) - 1;
+		} else {
+			rateidx = ffs(info->basic_rates);
+			if (rateidx)
+				rateidx -= 1;
+		}
 
 		if (ar->pdev->cap.supported_bands & WMI_HOST_WLAN_5G_CAP)
 			rateidx += ATH12K_MAC_FIRST_OFDM_RATE_IDX;