@@ -79,45 +79,3 @@ ov8856_ep: endpoint {
};
};
};
-
-&cci_i2c1 {
- #address-cells = <1>;
- #size-cells = <0>;
-
- camera@60 {
- compatible = "ovti,ov7251";
-
- /* I2C address as per ov7251.txt linux documentation */
- reg = <0x60>;
-
- /* CAM3_RST_N */
- enable-gpios = <&tlmm 21 GPIO_ACTIVE_HIGH>;
- pinctrl-names = "default";
- pinctrl-0 = <&cam3_default>;
-
- clocks = <&clock_camcc CAM_CC_MCLK3_CLK>;
- clock-names = "xclk";
- clock-frequency = <24000000>;
-
- /*
- * The &vreg_s4a_1p8 trace always powered on.
- *
- * The 2.8V vdda-supply regulator is enabled when the
- * vreg_s4a_1p8 trace is pulled high.
- * It too is represented by a fixed regulator.
- *
- * No 1.2V vddd-supply regulator is used.
- */
- vdddo-supply = <&vreg_lvs1a_1p8>;
- vdda-supply = <&cam3_avdd_2v8>;
-
- status = "disabled";
-
- port {
- ov7251_ep: endpoint {
- data-lanes = <0 1>;
-/* remote-endpoint = <&csiphy3_ep>; */
- };
- };
- };
-};
The ov7251node has bindings check errors in the endpoint, and the camera node was disabled since the beginning. Even when switching the node to okay, the endpoint description to the csiphy is missing along with the csiphy parameters. Drop the ov7251 camera entirely until it's properly described. This obviously fixes: sdm845-db845c-navigation-mezzanine.dtso: camera@60: port:endpoint:data-lanes: [0, 1] is too long from schema $id: http://devicetree.org/schemas/media/i2c/ovti,ov7251.yaml# Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org> --- .../qcom/sdm845-db845c-navigation-mezzanine.dtso | 42 ---------------------- 1 file changed, 42 deletions(-)