@@ -3992,6 +3992,36 @@ Cancel Transmit Mesh Packet Command
Possible errors: Failed
Invalid Parameters
+Send HCI command and wait for event Command
+===========================================
+
+ Command Code: 0x005B
+ Controller Index: <controller id>
+ Command Parameters: Opcode (2 Octets)
+ Event (1 Octet)
+ Timeout (1 Octet)
+ Parameter Length (2 Octets)
+ Parameter (variable)
+ Return Parameters: Response (1-variable Octets)
+
+ This command may be used to send a HCI command and wait for an
+ (optional) event.
+
+ The HCI command is specified by the Opcode, any arbitrary is supported
+ including vendor commands, but contrary to the like of
+ Raw/User channel it is run as an HCI command send by the kernel
+ since it uses its command synchronization thus it is possible to wait
+ for a specific event as a response.
+
+ Setting event to 0x00 will cause the command to wait for either
+ HCI Command Status or HCI Command Complete.
+
+ Timeout is specified in seconds, setting it to 0 will cause the
+ default timeout to be used.
+
+ Possible errors: Failed
+ Invalid Parameters
+
Command Complete Event
======================
From: Luiz Augusto von Dentz <luiz.von.dentz@intel.com> This adds Send HCI command and wait for event Command initial documentation. --- doc/mgmt-api.txt | 30 ++++++++++++++++++++++++++++++ 1 file changed, 30 insertions(+)