@@ -11,12 +11,12 @@
* This means that framebuffers should pass it as
* DIO_ENCODE_ID(DIO_ID_FBUFFER,DIO_ID2_TOPCAT)
* (or whatever); everybody else just uses DIO_ID_FOOBAR.
- * unsigned long dio_scodetophysaddr(int scode)
+ * unsigned long dio_scode_to_physaddr(int scode)
* Return the physical address corresponding to the given select code.
- * int dio_scodetoipl(int scode)
+ * int dio_scode_to_ipl(int scode)
* Every DIO card has a fixed interrupt priority level. This function
* returns it, whatever it is.
- * const char *dio_scodetoname(int scode)
+ * const char *dio_scode_to_name(int scode)
* Return a character string describing this board [might be "" if
* not CONFIG_DIO_CONSTANTS]
* void dio_config_board(int scode) mark board as configured in the list
@@ -130,7 +130,7 @@ int __init dio_find(int deviceid)
if (DIO_SCINHOLE(scode))
continue;
- pa = dio_scodetophysaddr(scode);
+ pa = dio_scode_to_physaddr(scode);
if (!pa)
continue;
@@ -203,7 +203,7 @@ static int __init dio_init(void)
if (DIO_SCINHOLE(scode))
continue;
- pa = dio_scodetophysaddr(scode);
+ pa = dio_scode_to_physaddr(scode);
if (!pa)
continue;
@@ -274,7 +274,7 @@ subsys_initcall(dio_init);
/* Bear in mind that this is called in the very early stages of initialisation
* in order to get the address of the serial port for the console...
*/
-unsigned long dio_scodetophysaddr(int scode)
+unsigned long dio_scode_to_physaddr(int scode)
{
if (scode >= DIOII_SCBASE)
return (DIOII_BASE + (scode - 132) * DIOII_DEVSIZE);
@@ -124,7 +124,7 @@ int __init hp300_setup_serial_console(void)
#endif
} else {
#ifdef CONFIG_HPDCA
- unsigned long pa = dio_scodetophysaddr(scode);
+ unsigned long pa = dio_scode_to_physaddr(scode);
if (!pa)
return 0;
@@ -241,7 +241,7 @@ struct dio_driver {
*/
extern int dio_find(int deviceid);
-extern unsigned long dio_scodetophysaddr(int scode);
+extern unsigned long dio_scode_to_physaddr(int scode);
extern int dio_create_sysfs_dev_files(struct dio_dev *);
/* New-style probing */
Rename dio_scodetophysaddr to dio_scode_to_physaddr. Also dio_scodetoipl -> dio_scode_to_ipl and dio_scode_to_name -> dio_scode_to_name, though they're not implemented yet. I've searched these names in the repo. There are only a few of references. I think it's OK and worth renaming them for readability. Signed-off-by: winterver <295107659@qq.com> --- drivers/dio/dio.c | 12 ++++++------ drivers/tty/serial/8250/8250_hp300.c | 2 +- include/linux/dio.h | 2 +- 3 files changed, 8 insertions(+), 8 deletions(-)