@@ -453,6 +453,17 @@ void __i2c_dw_disable(struct dw_i2c_dev *dev)
abort_needed = raw_intr_stats & DW_IC_INTR_MST_ON_HOLD;
if (abort_needed) {
+ if (!(enable & DW_IC_ENABLE_ENABLE)) {
+ regmap_write(dev->map, DW_IC_ENABLE, DW_IC_ENABLE_ENABLE);
+ enable |= DW_IC_ENABLE_ENABLE;
+ /*
+ * Wait two ic_clk delay when enabling the I2C to ensure ENABLE bit
+ * is already set by the driver (for 400KHz this is 25us)
+ * as described in the DesignWare I2C databook.
+ */
+ fsleep(25);
+ }
+
regmap_write(dev->map, DW_IC_ENABLE, enable | DW_IC_ENABLE_ABORT);
ret = regmap_read_poll_timeout(dev->map, DW_IC_ENABLE, enable,
!(enable & DW_IC_ENABLE_ABORT), 10,
It was observed issuing ABORT bit(IC_ENABLE[1]) will not work when IC_ENABLE is already disabled. Check if ENABLE bit(IC_ENABLE[0]) is disabled when the master is holding SCL low. If ENABLE bit is disabled, the software need enable it before trying to issue ABORT bit. otherwise, the controller ignores any write to ABORT bit. Signed-off-by: Kimriver Liu <kimriver.liu@siengine.com> --- V4->V5: delete master idling checking V3->V4: 1. update commit messages and add patch version and changelog 2. move print the error message in i2c_dw_xfer V2->V3: change (!enable) to (!(enable & DW_IC_ENABLE_ENABLE)) V1->V2: used standard words in function names and addressed review comments link to V1: https://lore.kernel.org/lkml/20240904064224.2394-1-kimriver.liu@siengine.com/ --- drivers/i2c/busses/i2c-designware-common.c | 11 +++++++++++ 1 file changed, 11 insertions(+)