new file mode 100644
@@ -0,0 +1,92 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/mmc/atmel,sama5d2-sdhci.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Atmel SDHCI controller
+
+maintainers:
+ - Aubin Constans <aubin.constans@microchip.com>
+ - Nicolas Ferre <nicolas.ferre@microchip.com>
+
+description:
+ Bindings for the SDHCI controller found in Atmel/Microchip SoCs.
+
+properties:
+ compatible:
+ oneOf:
+ - enum:
+ - atmel,sama5d2-sdhci
+ - microchip,sam9x60-sdhci
+ - items:
+ - enum:
+ - microchip,sam9x7-sdhci
+ - microchip,sama7g5-sdhci
+ - const: microchip,sam9x60-sdhci
+
+ reg:
+ maxItems: 1
+
+ interrupts:
+ maxItems: 1
+
+ clocks:
+ items:
+ - description: hclock
+ - description: multclk
+ - description: baseclk
+ minItems: 2
+
+ clock-names:
+ items:
+ - const: hclock
+ - const: multclk
+ - const: baseclk
+ minItems: 2
+
+ microchip,sdcal-inverted:
+ type: boolean
+ description:
+ When present, polarity on the SDCAL SoC pin is inverted. The default
+ polarity for this signal is described in the datasheet. For instance on
+ SAMA5D2, the pin is usually tied to the GND with a resistor and a
+ capacitor (see "SDMMC I/O Calibration" chapter).
+
+required:
+ - compatible
+ - reg
+ - interrupts
+ - clocks
+ - clock-names
+
+allOf:
+ - $ref: sdhci-common.yaml#
+ - if:
+ properties:
+ compatible:
+ contains:
+ enum:
+ - atmel,sama5d2-sdhci
+ then:
+ properties:
+ clocks:
+ minItems: 3
+ clock-names:
+ minItems: 3
+
+unevaluatedProperties: false
+
+examples:
+ - |
+ #include <dt-bindings/interrupt-controller/irq.h>
+ #include <dt-bindings/clock/at91.h>
+ mmc@a0000000 {
+ compatible = "atmel,sama5d2-sdhci";
+ reg = <0xa0000000 0x300>;
+ interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>;
+ clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>;
+ clock-names = "hclock", "multclk", "baseclk";
+ assigned-clocks = <&sdmmc0_gclk>;
+ assigned-clock-rates = <480000000>;
+ };
deleted file mode 100644
@@ -1,35 +0,0 @@
-* Atmel SDHCI controller
-
-This file documents the differences between the core properties in
-Documentation/devicetree/bindings/mmc/mmc.txt and the properties used by the
-sdhci-of-at91 driver.
-
-Required properties:
-- compatible: Must be "atmel,sama5d2-sdhci" or "microchip,sam9x60-sdhci"
- or "microchip,sam9x7-sdhci", "microchip,sam9x60-sdhci".
-- clocks: Phandlers to the clocks.
-- clock-names: Must be "hclock", "multclk", "baseclk" for
- "atmel,sama5d2-sdhci".
- Must be "hclock", "multclk" for "microchip,sam9x60-sdhci".
- Must be "hclock", "multclk" for "microchip,sam9x7-sdhci".
-
-Optional properties:
-- assigned-clocks: The same with "multclk".
-- assigned-clock-rates The rate of "multclk" in order to not rely on the
- gck configuration set by previous components.
-- microchip,sdcal-inverted: when present, polarity on the SDCAL SoC pin is
- inverted. The default polarity for this signal is described in the datasheet.
- For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
- and a capacitor (see "SDMMC I/O Calibration" chapter).
-
-Example:
-
-mmc0: sdio-host@a0000000 {
- compatible = "atmel,sama5d2-sdhci";
- reg = <0xa0000000 0x300>;
- interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>;
- clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>;
- clock-names = "hclock", "multclk", "baseclk";
- assigned-clocks = <&sdmmc0_gclk>;
- assigned-clock-rates = <480000000>;
-};
Convert sdhci-atmel documentation to yaml format. The new file will inherit from sdhci-common.yaml. Note: Add microchip,sama7g5-sdhci to compatible list as we already use it in the DT. Signed-off-by: Dharma Balasubiramani <dharma.b@microchip.com> --- This patch series converts the sdhci-atmel dt-binding to yaml format and adds the sama7d65,sama7g5 compatibles to the list. --- Changes in v4: - remove the "atmel,sama5d3-sdhci" and "atmel,sama5d4-sdhci" compatibles and add back the "microchip,sam9x7-sdhci" compatible from old binding which was missed. - drop the addition of sama7d65 in binding, will be sent along with the dts patch series. - Add the entire description of "microchip,sdcal-inverted" from old txt binding. - The microchip,sam9x7-sdhci is yet to be merged in DTS https://lore.kernel.org/lkml/20240729070934.1991467-1-varshini.rajendran@microchip.com/ - Link to v3: https://lore.kernel.org/r/20240830-atmel-sdhci-v3-0-7c97a0872af4@microchip.com Changes in v3: - update the items in clocks instead of plain description. - move the items list to clock-names. - since baseclk is must, change maxitems to minitems: 3, and modify the conditional bits accordingly. - Link to v2: https://lore.kernel.org/r/20240830-atmel-sdhci-v2-0-b7f58973f3fc@microchip.com Changes in v2: - Add missing deleted file to the patch "Documentation/devicetree/bindings/mmc/sdhci-atmel.txt" - Link to v1: https://lore.kernel.org/r/20240830-atmel-sdhci-v1-0-01e3ec8c9804@microchip.com --- .../bindings/mmc/atmel,sama5d2-sdhci.yaml | 92 ++++++++++++++++++++++ .../devicetree/bindings/mmc/sdhci-atmel.txt | 35 -------- 2 files changed, 92 insertions(+), 35 deletions(-) --- base-commit: 4b7d983dd85a5cdf4938f4a0a93adedf697ac04d change-id: 20240830-atmel-sdhci-c9a92b710624 Best regards,