diff mbox series

[v4,3/7] i2c: qcom-cci: Stop complaining about DT set clock rate

Message ID 20240904020448.52035-12-mailingradian@gmail.com
State Superseded
Headers show
Series [v4,1/7] dt-bindings: clock: qcom,sdm845-camcc: add sdm670 compatible | expand

Commit Message

Richard Acayan Sept. 4, 2024, 2:04 a.m. UTC 
From: Bryan O'Donoghue <bryan.odonoghue@linaro.org>

It is common practice in the downstream and upstream CCI dt to set CCI
clock rates to 19.2 MHz. It appears to be fairly common for initial code to
set the CCI clock rate to 37.5 MHz.

Applying the widely used CCI clock rates from downstream ought not to cause
warning messages in the upstream kernel where our general policy is to
usually copy downstream hardware clock rates across the range of Qualcomm
drivers.

Drop the warning it is pervasive across CAMSS users but doesn't add any
information or warrant any changes to the DT to align the DT clock rate to
the bootloader clock rate.

Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
Link: https://lore.kernel.org/linux-arm-msm/20240824115900.40702-1-bryan.odonoghue@linaro.org
Signed-off-by: Richard Acayan <mailingradian@gmail.com>
---
 drivers/i2c/busses/i2c-qcom-cci.c | 8 --------
 1 file changed, 8 deletions(-)
diff mbox series

Patch

diff --git a/drivers/i2c/busses/i2c-qcom-cci.c b/drivers/i2c/busses/i2c-qcom-cci.c
index 414882c57d7f..99e4305a3373 100644
--- a/drivers/i2c/busses/i2c-qcom-cci.c
+++ b/drivers/i2c/busses/i2c-qcom-cci.c
@@ -602,14 +602,6 @@  static int cci_probe(struct platform_device *pdev)
 		}
 	}
 
-	if (cci_clk_rate != cci->data->cci_clk_rate) {
-		/* cci clock set by the bootloader or via assigned clock rate
-		 * in DT.
-		 */
-		dev_warn(dev, "Found %lu cci clk rate while %lu was expected\n",
-			 cci_clk_rate, cci->data->cci_clk_rate);
-	}
-
 	ret = cci_enable_clocks(cci);
 	if (ret < 0)
 		return ret;