diff mbox series

[dt-schema,1/3] schemas: i2c: reword descriptions for inclusive language

Message ID 20240815120935.5871-2-wsa+renesas@sang-engineering.com
State New
Headers show
Series schemas: i2c: fix "smbus_alert" handling | expand

Commit Message

Wolfram Sang Aug. 15, 2024, 12:09 p.m. UTC
Changing bindings is hard, changing descriptions is easy. Let's start
with the low-hanging fruits and use the official I2C terminology (as of
specs v7) in the descriptions. Drop a superfluous 'a' from the
description of 'reg' for targets.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
 dtschema/schemas/i2c/i2c-controller.yaml | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)
diff mbox series

Patch

diff --git a/dtschema/schemas/i2c/i2c-controller.yaml b/dtschema/schemas/i2c/i2c-controller.yaml
index 9670082..e475ead 100644
--- a/dtschema/schemas/i2c/i2c-controller.yaml
+++ b/dtschema/schemas/i2c/i2c-controller.yaml
@@ -99,7 +99,7 @@  properties:
   multi-master:
     type: boolean
     description:
-      States that there is another master active on this bus. The OS can use
+      States that there is another controller active on this bus. The OS can use
       this information to adapt power management to keep the arbitration awake
       all the time, for example. Can not be combined with 'single-master'.
 
@@ -116,9 +116,9 @@  properties:
   single-master:
     type: boolean
     description:
-      States that there is no other master active on this bus. The OS can use
-      this information to detect a stalled bus more reliably, for example. Can
-      not be combined with 'multi-master'.
+      States that there is no other controller active on this bus. The OS can
+      use this information to detect a stalled bus more reliably, for example.
+      Can not be combined with 'multi-master'.
 
   smbus:
     type: boolean
@@ -155,7 +155,7 @@  patternProperties:
                 - minimum: 0xc0000000
                   maximum: 0xc00003ff
         description: |
-          One or many I2C slave addresses. These are usually a 7 bit addresses.
+          One or many I2C target addresses. These are usually 7 bit addresses.
           However, flags can be attached to an address. I2C_TEN_BIT_ADDRESS is
           used to mark a 10 bit address. It is needed to avoid the ambiguity
           between e.g. a 7 bit address of 0x50 and a 10 bit address of 0x050
@@ -172,7 +172,7 @@  patternProperties:
       interrupts:
         description:
           I2C core will treat "irq" interrupt (or the very first interrupt if
-          not using interrupt names) as primary interrupt for the slave.
+          not using interrupt names) as primary interrupt for the target.
 
       interrupt-names:
         anyOf: