diff mbox series

tty: serial: fsl_lpuart: mark last busy before uart_add_one_port

Message ID 20240808140325.580105-1-peng.fan@oss.nxp.com
State New
Headers show
Series tty: serial: fsl_lpuart: mark last busy before uart_add_one_port | expand

Commit Message

Peng Fan (OSS) Aug. 8, 2024, 2:03 p.m. UTC 
From: Peng Fan <peng.fan@nxp.com>

With "earlycon initcall_debug=1 loglevel=8" in bootargs, kernel
sometimes boot hang. It is because normal console still is not ready,
but runtime suspend is called, so early console putchar will hang
in waiting TRDE set in UARTSTAT.

The lpuart driver has auto suspend delay set to 3000ms, but during
uart_add_one_port, a child device serial ctrl will added and probed with
its pm runtime enabled(see serial_ctrl.c).
The runtime suspend call path is:
device_add
     |-> bus_probe_device
           |->device_initial_probe
	           |->__device_attach
                         |-> pm_runtime_get_sync(dev->parent);
			 |-> pm_request_idle(dev);
			 |-> pm_runtime_put(dev->parent);

So in the end, before normal console ready, the lpuart get runtime
suspended. And earlycon putchar will hang.

To address the issue, mark last busy just after pm_runtime_enable,
three seconds is long enough to switch from bootconsole to normal
console.

Fixes: 43543e6f539b ("tty: serial: fsl_lpuart: Add runtime pm support")
Signed-off-by: Peng Fan <peng.fan@nxp.com>
---
 drivers/tty/serial/fsl_lpuart.c | 1 +
 1 file changed, 1 insertion(+)
diff mbox series

Patch

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 615291ea9b5e..77efa7ee6eda 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -2923,6 +2923,7 @@  static int lpuart_probe(struct platform_device *pdev)
 	pm_runtime_set_autosuspend_delay(&pdev->dev, UART_AUTOSUSPEND_TIMEOUT);
 	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);
+	pm_runtime_mark_last_busy(&pdev->dev);
 
 	ret = lpuart_global_reset(sport);
 	if (ret)