diff mbox series

[2/4] serial: amba-pl011: move variable into CONFIG_DMA_ENGINE conditional

Message ID 20240407002709.16224-3-l.sanfilippo@kunbus.com
State New
Headers show
Series RS485 cleanups | expand

Commit Message

Lino Sanfilippo April 7, 2024, 12:27 a.m. UTC
Variable dmacr is only used if DMA is enabled, so move it into the
CONFIG_DMA_ENGINE conditional.

Signed-off-by: Lino Sanfilippo <l.sanfilippo@kunbus.com>
---
 drivers/tty/serial/amba-pl011.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index 3d2dac0ebcde..349005e6ab9f 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -256,7 +256,6 @@  struct uart_amba_port {
 	const u16		*reg_offset;
 	struct clk		*clk;
 	const struct vendor_data *vendor;
-	unsigned int		dmacr;		/* dma control reg */
 	unsigned int		im;		/* interrupt mask */
 	unsigned int		old_status;
 	unsigned int		fifosize;	/* vendor-specific */
@@ -266,6 +265,7 @@  struct uart_amba_port {
 	unsigned int		rs485_tx_drain_interval; /* usecs */
 #ifdef CONFIG_DMA_ENGINE
 	/* DMA stuff */
+	unsigned int		dmacr;		/* dma control reg */
 	bool			using_tx_dma;
 	bool			using_rx_dma;
 	struct pl011_dmarx_data dmarx;