@@ -234,7 +234,7 @@ static int ingenic_uart_probe(struct platform_device *pdev)
struct ingenic_uart_data *data;
const struct ingenic_uart_config *cdata;
struct resource *regs;
- int irq, err, line;
+ int err;
cdata = of_device_get_match_data(&pdev->dev);
if (!cdata) {
@@ -242,10 +242,6 @@ static int ingenic_uart_probe(struct platform_device *pdev)
return -ENODEV;
}
- irq = platform_get_irq(pdev, 0);
- if (irq < 0)
- return irq;
-
regs = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!regs) {
dev_err(&pdev->dev, "no registers defined\n");
@@ -259,21 +255,19 @@ static int ingenic_uart_probe(struct platform_device *pdev)
spin_lock_init(&uart.port.lock);
uart.port.type = PORT_16550A;
uart.port.flags = UPF_SKIP_TEST | UPF_IOREMAP | UPF_FIXED_TYPE;
- uart.port.iotype = UPIO_MEM;
uart.port.mapbase = regs->start;
- uart.port.regshift = 2;
uart.port.serial_out = ingenic_uart_serial_out;
uart.port.serial_in = ingenic_uart_serial_in;
- uart.port.irq = irq;
uart.port.dev = &pdev->dev;
- uart.port.fifosize = cdata->fifosize;
uart.tx_loadsz = cdata->tx_loadsz;
uart.capabilities = UART_CAP_FIFO | UART_CAP_RTOIE;
- /* Check for a fixed line number */
- line = of_alias_get_id(pdev->dev.of_node, "serial");
- if (line >= 0)
- uart.port.line = line;
+ err = uart_read_port_properties(&uart.port, true);
+ if (err)
+ return err;
+
+ uart.port.regshift = 2;
+ uart.port.fifosize = cdata->fifosize;
uart.port.membase = devm_ioremap(&pdev->dev, regs->start,
resource_size(regs));
Since we have now a common helper to read port properties use it instead of sparse home grown solution. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/tty/serial/8250/8250_ingenic.c | 20 +++++++------------- 1 file changed, 7 insertions(+), 13 deletions(-)