@@ -92,11 +92,7 @@ static int lpc18xx_serial_probe(struct platform_device *pdev)
struct lpc18xx_uart_data *data;
struct uart_8250_port uart;
struct resource *res;
- int irq, ret;
-
- irq = platform_get_irq(pdev, 0);
- if (irq < 0)
- return irq;
+ int ret;
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!res) {
@@ -139,19 +135,12 @@ static int lpc18xx_serial_probe(struct platform_device *pdev)
goto dis_clk_reg;
}
- ret = of_alias_get_id(pdev->dev.of_node, "serial");
- if (ret >= 0)
- uart.port.line = ret;
-
data->dma.rx_param = data;
data->dma.tx_param = data;
spin_lock_init(&uart.port.lock);
uart.port.dev = &pdev->dev;
- uart.port.irq = irq;
- uart.port.iotype = UPIO_MEM32;
uart.port.mapbase = res->start;
- uart.port.regshift = 2;
uart.port.type = PORT_16550A;
uart.port.flags = UPF_FIXED_PORT | UPF_FIXED_TYPE | UPF_SKIP_TEST;
uart.port.uartclk = clk_get_rate(data->clk_uart);
@@ -160,6 +149,13 @@ static int lpc18xx_serial_probe(struct platform_device *pdev)
uart.port.rs485_supported = lpc18xx_rs485_supported;
uart.port.serial_out = lpc18xx_uart_serial_out;
+ ret = uart_read_port_properties(&uart.port, true);
+ if (ret)
+ return ret;
+
+ uart.port.iotype = UPIO_MEM32;
+ uart.port.regshift = 2;
+
uart.dma = &data->dma;
uart.dma->rxconf.src_maxburst = 1;
uart.dma->txconf.dst_maxburst = 1;
Since we have now a common helper to read port properties use it instead of sparse home grown solution. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/tty/serial/8250/8250_lpc18xx.c | 20 ++++++++------------ 1 file changed, 8 insertions(+), 12 deletions(-)