@@ -14,6 +14,7 @@
#include <linux/clk.h>
#include <linux/i2c.h>
+#include <linux/iopoll.h>
#include <linux/interrupt.h>
#include <linux/io.h>
#include <linux/module.h>
@@ -348,14 +349,19 @@ static int uniphier_fi2c_master_xfer_one(struct i2c_adapter *adap,
dev_dbg(&adap->dev, "complete\n");
if (unlikely(priv->flags & UNIPHIER_FI2C_DEFER_STOP_COMP)) {
- u32 status = readl(priv->membase + UNIPHIER_FI2C_SR);
-
- if (!(status & UNIPHIER_FI2C_SR_STS) ||
- status & UNIPHIER_FI2C_SR_BB) {
+ u32 status;
+ int ret;
+
+ ret = readl_poll_timeout(priv->membase + UNIPHIER_FI2C_SR,
+ status,
+ (status & UNIPHIER_FI2C_SR_STS) &&
+ !(status & UNIPHIER_FI2C_SR_BB),
+ 1, 20);
+ if (ret) {
dev_err(&adap->dev,
"stop condition was not completed.\n");
uniphier_fi2c_recover(priv);
- return -EBUSY;
+ return ret;
}
}
Currently, the status register FI2C_SR is checked immediately after a STOP condition is issued in case of the deferred STOP condition. It takes typically 5-10 usec until the corresponding bits in the register are set, so the error check for "stop condition was not completed" is very likely to be false positive. Add wait code to relax the status register check. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Changes in v2: - use readl_poll_timeout() drivers/i2c/busses/i2c-uniphier-f.c | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html