@@ -10,10 +10,21 @@
#include <linux/gpio/consumer.h>
#include <linux/delay.h>
#include <linux/of_device.h>
+#include <linux/mfd/syscon.h>
+#include <linux/regmap.h>
#include "pcie-cadence.h"
#include "pci-j721e.h"
+#define CTRL_MMR_LOCK2_MASK 0xFFFFFFFF
+#define CTRL_MMR_LOCK2_KICK0_UNLOCK_VAL 0x68EF3490
+#define CTRL_MMR_LOCK2_KICK1_UNLOCK_VAL 0xD172BC5A
+#define CTRL_MMR_LOCK_KICK_LOCK_VAL 0xFFFFFFFF
+#define CTRL_MMR_ACSPCIE_PAD_MASK 0xFFFFFFFF
+#define CTRL_MMR_ACSPCIE_PAD_EN 0x01000000
+#define PCIE_REFCLK_CLKSEL_OUT_EN BIT(8)
+#define PCIE_REFCLK_CLKSEL_MASK GENMASK(1, 0)
+
static int cdns_ti_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
int where, int size, u32 *value)
{
@@ -79,6 +90,84 @@ static const struct of_device_id of_j721e_pcie_host_match[] = {
};
MODULE_DEVICE_TABLE(of, of_j721e_pcie_host_match);
+static int j721e_enable_acspcie(struct j721e_pcie *pcie)
+{
+ struct device *dev = pcie->cdns_pcie->dev;
+ struct device_node *node = dev->of_node;
+ struct of_phandle_args args;
+ unsigned int lock2_kick0_offset, lock2_kick1_offset;
+ unsigned int acspcie_pad_offset, refclk_clksel_offset;
+ unsigned int refclk_clksel_source;
+ struct regmap *syscon;
+ u32 val = 0, mask = 0;
+ int ret;
+
+ /*
+ * If property ti,syscon-pcie-refclk-out exists, believe PCIe connector
+ * requires PCIe ref clock from Serdes, so enable ACSPCIE pads and mux
+ * to source out PCIe ref clock else ref clock has to be supplied from
+ * on-board clock generator.
+ */
+ syscon = syscon_regmap_lookup_by_phandle(node, "ti,syscon-pcie-refclk-out");
+ if (IS_ERR(syscon))
+ return 0;
+
+ ret = of_parse_phandle_with_fixed_args(node, "ti,syscon-pcie-refclk-out", 5,
+ 0, &args);
+ if (ret) {
+ dev_err(dev, "Failed to read ti,syscon-pcie-refclk-out property\n");
+ return ret;
+ }
+
+ lock2_kick0_offset = args.args[0];
+ lock2_kick1_offset = args.args[1];
+ acspcie_pad_offset = args.args[2];
+ refclk_clksel_offset = args.args[3];
+ refclk_clksel_source = args.args[4];
+
+ /* Un-lock Partition 2 : 8000h to 9FFFh */
+ mask = CTRL_MMR_LOCK2_MASK;
+ val = CTRL_MMR_LOCK2_KICK0_UNLOCK_VAL;
+ ret = regmap_update_bits(syscon, lock2_kick0_offset, mask, val);
+ if (ret)
+ goto err;
+
+ val = CTRL_MMR_LOCK2_KICK1_UNLOCK_VAL;
+ ret = regmap_update_bits(syscon, lock2_kick1_offset, mask, val);
+ if (ret)
+ goto err;
+
+ /* Enable ACSPCIe PADS */
+ mask = CTRL_MMR_ACSPCIE_PAD_MASK;
+ val = CTRL_MMR_ACSPCIE_PAD_EN;
+ ret = regmap_update_bits(syscon, acspcie_pad_offset, mask, val);
+ if (ret)
+ goto err;
+
+ /* PCIE_REFCLKx_CLKSEL : EN + ref_clk_source */
+ mask = PCIE_REFCLK_CLKSEL_OUT_EN | PCIE_REFCLK_CLKSEL_MASK;
+ val = PCIE_REFCLK_CLKSEL_OUT_EN | refclk_clksel_source;
+ ret = regmap_update_bits(syscon, refclk_clksel_offset, mask, val);
+ if (ret)
+ goto err;
+
+ /* Re-lock Partition 2 : 8000h to 9FFFh */
+ mask = CTRL_MMR_LOCK_KICK_LOCK_VAL;
+ val = CTRL_MMR_LOCK_KICK_LOCK_VAL;
+ ret = regmap_update_bits(syscon, lock2_kick0_offset, mask, val);
+ if (ret)
+ goto err;
+
+ ret = regmap_update_bits(syscon, lock2_kick1_offset, mask, val);
+ if (ret)
+ goto err;
+
+ return 0;
+err:
+ dev_err(dev, "Failed to enable ref clock out\n");
+ return ret;
+}
+
static int j721e_pcie_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
@@ -121,6 +210,13 @@ static int j721e_pcie_probe(struct platform_device *pdev)
if (ret)
return ret;
+ /*
+ * Enable ACSPCIe clock buffer to source out reference clock for EP
+ */
+ ret = j721e_enable_acspcie(pcie);
+ if (ret < 0)
+ return ret;
+
pcie->perst_gpiod = devm_gpiod_get(dev, "reset", GPIOD_OUT_LOW);
if (IS_ERR(pcie->perst_gpiod)) {
ret = PTR_ERR(pcie->perst_gpiod);
PCIe1 in J7AHP EVM has EP side connector reference clock connection from serdes named SOC_SERDES0_REFCLK(PCIE_REFCLK_OUT) unlike PCIe0 which has reference clock connection from on-board serdes. To enable this reference clock out, ACSPCIE clock buffer pads have to be enabled. This change enables ACSPCIE clock buffer pads and select clock source for reference clock output. Signed-off-by: Achal Verma <a-verma1@ti.com> --- .../pci/controller/cadence/pci-j721e-host.c | 96 +++++++++++++++++++ 1 file changed, 96 insertions(+)