@@ -1,6 +1,6 @@
/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
/*
- * Copyright (C) 2005-2014 Intel Corporation
+ * Copyright (C) 2005-2014, 2023 Intel Corporation
*/
/*
* Please use this file (commands.h) only for uCode API definitions.
@@ -270,7 +270,7 @@ enum {
#define IWL_PWR_NUM_HT_OFDM_ENTRIES 24
#define IWL_PWR_CCK_ENTRIES 2
-/**
+/*
* struct tx_power_dual_stream
*
* Table entries in REPLY_TX_PWR_TABLE_CMD, REPLY_CHANNEL_SWITCH
@@ -281,7 +281,7 @@ struct tx_power_dual_stream {
__le32 dw;
} __packed;
-/**
+/*
* Command REPLY_TX_POWER_DBM_CMD = 0x98
* struct iwlagn_tx_power_dbm_cmd
*/
@@ -295,7 +295,7 @@ struct iwlagn_tx_power_dbm_cmd {
u8 reserved;
} __packed;
-/**
+/*
* Command TX_ANT_CONFIGURATION_CMD = 0x98
* This command is used to configure valid Tx antenna.
* By default uCode concludes the valid antenna according to the radio flavor.
@@ -313,7 +313,7 @@ struct iwl_tx_ant_config_cmd {
#define UCODE_VALID_OK cpu_to_le32(0x1)
-/**
+/*
* REPLY_ALIVE = 0x1 (response only, not a command)
*
* uCode issues this "alive" notification once the runtime image is ready
@@ -534,7 +534,7 @@ enum {
/* transfer to host non bssid beacons in associated state */
#define RXON_FILTER_BCON_AWARE_MSK cpu_to_le32(1 << 6)
-/**
+/*
* REPLY_RXON = 0x10 (command, has simple generic response)
*
* RXON tunes the radio tuner to a service channel, and sets up a number
@@ -681,6 +681,7 @@ struct iwl_csa_notification {
* @aifsn: Number of slots in Arbitration Interframe Space (before
* performing random backoff timing prior to Tx). Device default 1.
* @edca_txop: Length of Tx opportunity, in uSecs. Device default is 0.
+ * @reserved1: reserved for alignment
*
* Device will automatically increase contention window by (2*CW) + 1 for each
* transmission retry. Device uses cw_max as a bit mask, ANDed with new CW
@@ -791,9 +792,11 @@ struct iwl_keyinfo {
/**
* struct sta_id_modify
- * @addr[ETH_ALEN]: station's MAC address
+ * @addr: station's MAC address
+ * @reserved1: reserved for alignment
* @sta_id: index of station in uCode's station table
* @modify_mask: STA_MODIFY_*, 1: modify, 0: don't change
+ * @reserved2: reserved for alignment
*
* Driver selects unused table index when adding new station,
* or the index to a pre-existing station entry when modifying that station.
@@ -1464,7 +1467,7 @@ struct iwl_compressed_ba_resp {
#define LINK_QUAL_ANT_MSK (LINK_QUAL_ANT_A_MSK|LINK_QUAL_ANT_B_MSK)
-/**
+/*
* struct iwl_link_qual_general_params
*
* Used in REPLY_TX_LINK_QUALITY_CMD
@@ -1507,7 +1510,7 @@ struct iwl_link_qual_general_params {
#define LINK_QUAL_AGG_FRAME_LIMIT_MAX (63)
#define LINK_QUAL_AGG_FRAME_LIMIT_MIN (0)
-/**
+/*
* struct iwl_link_qual_agg_params
*
* Used in REPLY_TX_LINK_QUALITY_CMD
@@ -2040,7 +2043,7 @@ struct iwl_spectrum_notification {
*
*****************************************************************************/
-/**
+/*
* struct iwl_powertable_cmd - Power Table Command
* @flags: See below:
*
@@ -2171,7 +2174,7 @@ struct iwl_ct_kill_throttling_config {
#define SCAN_CHANNEL_TYPE_PASSIVE cpu_to_le32(0)
#define SCAN_CHANNEL_TYPE_ACTIVE cpu_to_le32(1)
-/**
+/*
* struct iwl_scan_channel - entry in REPLY_SCAN_CMD channel table
*
* One for each channel in the scan list.
@@ -2210,7 +2213,7 @@ struct iwl_scan_channel {
/* set number of direct probes __le32 type */
#define IWL_SCAN_PROBE_MASK(n) cpu_to_le32((BIT(n) | (BIT(n) - BIT(1))))
-/**
+/*
* struct iwl_ssid_ie - directed scan network information element
*
* Up to 20 of these may appear in REPLY_SCAN_CMD,
@@ -2560,6 +2563,7 @@ struct statistics_rx_bt {
* @ant_a: current tx power on chain a in 1/2 dB step
* @ant_b: current tx power on chain b in 1/2 dB step
* @ant_c: current tx power on chain c in 1/2 dB step
+ * @reserved: reserved for alignment
*/
struct statistics_tx_power {
u8 ant_a;
@@ -3006,7 +3010,7 @@ struct iwl_enhance_sensitivity_cmd {
} __packed;
-/**
+/*
* REPLY_PHY_CALIBRATION_CMD = 0xb0 (command, has simple generic response)
*
* This command sets the relative gains of agn device's 3 radio receiver chains.
@@ -3847,6 +3851,7 @@ struct iwlagn_wowlan_status {
* @type:
* 0 - BSS
* 1 - PAN
+ * @reserved: reserved for alignment
*/
struct iwl_wipan_slot {
__le16 width;
@@ -3874,6 +3879,8 @@ struct iwl_wipan_slot {
* uCode will perform leaving channel methods in context switch
* also when working in same channel mode
* @num_slots: 1 - 10
+ * @slots: per-slot data
+ * @reserved: reserved for alignment
*/
struct iwl_wipan_params_cmd {
__le16 flags;
@@ -1,7 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0-only */
/******************************************************************************
*
- * Copyright(c) 2003 - 2014, 2020 Intel Corporation. All rights reserved.
+ * Copyright(c) 2003 - 2014, 2020, 2023 Intel Corporation. All rights reserved.
*****************************************************************************/
/*
* Please use this file (dev.h) for driver implementation definitions.
@@ -126,11 +126,11 @@ enum iwl_agg_state {
/**
* struct iwl_ht_agg - aggregation state machine
-
+ *
* This structs holds the states for the BA agreement establishment and tear
* down. It also holds the state during the BA session itself. This struct is
* duplicated for each RA / TID.
-
+ *
* @rate_n_flags: Rate at which Tx was attempted. Holds the data between the
* Tx response (REPLY_TX), and the block ack notification
* (REPLY_COMPRESSED_BA).
@@ -152,9 +152,9 @@ struct iwl_ht_agg {
/**
* struct iwl_tid_data - one for each RA / TID
-
+ *
* This structs holds the states for each RA / TID.
-
+ *
* @seq_number: the next WiFi sequence number to use
* @next_reclaimed: the WiFi sequence number of the next packet to be acked.
* This is basically (last acked packet++).
@@ -195,7 +195,7 @@ struct iwl_station_priv {
u8 sta_id;
};
-/**
+/*
* struct iwl_vif_priv - driver's private per-interface information
*
* When mac80211 allocates a virtual interface, it can allocate
@@ -529,6 +529,7 @@ enum iwl_scan_type {
* relevant for 1000, 6000 and up
* @struct iwl_sensitivity_ranges: range of sensitivity values
* @use_rts_for_aggregation: use rts/cts protection for HT traffic
+ * @sens: sensitivity ranges pointer
*/
struct iwl_hw_params {
u8 tx_chains_num;
@@ -547,6 +548,7 @@ struct iwl_hw_params {
* @bt_prio_boost: default bt priority boost value
* @agg_time_limit: maximum number of uSec in aggregation
* @bt_sco_disable: uCode should not response to BT in SCO/ESCO mode
+ * @bt_session_2: indicates version 2 of the BT command is used
*/
struct iwl_dvm_bt_params {
bool advanced_bt_coexist;
@@ -1,7 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0-only */
/******************************************************************************
*
- * Copyright(c) 2003 - 2014 Intel Corporation. All rights reserved.
+ * Copyright(c) 2003 - 2014, 2023 Intel Corporation. All rights reserved.
*****************************************************************************/
#ifndef __iwl_agn_rs_h__
@@ -269,7 +269,7 @@ struct iwl_rate_mcs_info {
char mcs[IWL_MAX_MCS_DISPLAY_SIZE];
};
-/**
+/*
* struct iwl_rate_scale_data -- tx success history for one rate
*/
struct iwl_rate_scale_data {
@@ -281,7 +281,7 @@ struct iwl_rate_scale_data {
unsigned long stamp;
};
-/**
+/*
* struct iwl_scale_tbl_info -- tx params and success history for all rates
*
* There are two of these in struct iwl_lq_sta,
@@ -311,7 +311,7 @@ struct iwl_traffic_load {
u8 head; /* start of the circular buffer */
};
-/**
+/*
* struct iwl_lq_sta -- driver's rate scaling private structure
*
* Pointer to this gets passed back and forth between driver and mac80211.
@@ -379,7 +379,7 @@ static inline u8 first_antenna(u8 mask)
void iwl_rs_rate_init(struct iwl_priv *priv, struct ieee80211_sta *sta,
u8 sta_id);
-/**
+/*
* iwl_rate_control_register - Register the rate control algorithm callbacks
*
* Since the rate control algorithm is hardware specific, there is no need
@@ -391,7 +391,7 @@ void iwl_rs_rate_init(struct iwl_priv *priv, struct ieee80211_sta *sta,
*/
int iwlagn_rate_control_register(void);
-/**
+/*
* iwl_rate_control_unregister - Unregister the rate control callbacks
*
* This should be called after calling ieee80211_unregister_hw, but before
@@ -1,7 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0-only */
/******************************************************************************
*
- * Copyright(c) 2007 - 2014 Intel Corporation. All rights reserved.
+ * Copyright(c) 2007 - 2014, 2023 Intel Corporation. All rights reserved.
*
* Portions of this file are derived from the ipw3945 project, as well
* as portions of the ieee80211 subsystem header files.
@@ -72,14 +72,15 @@ struct iwl_tt_trans {
* when thermal throttling state != IWL_TI_0
* the tt_power_mode should set to different
* power mode based on the current tt state
- * @tt_previous_temperature: last measured temperature
- * @iwl_tt_restriction: ptr to restriction tbl, used by advance
+ * @tt_previous_temp: last measured temperature
+ * @restriction: ptr to restriction tbl, used by advance
* thermal throttling to determine how many tx/rx streams
* should be used in tt state; and can HT be enabled or not
- * @iwl_tt_trans: ptr to adv trans table, used by advance thermal throttling
+ * @transaction: ptr to adv trans table, used by advance thermal throttling
* state transaction
* @ct_kill_toggle: used to toggle the CSR bit when checking uCode temperature
* @ct_kill_exit_tm: timer to exit thermal kill
+ * @ct_kill_waiting_tm: timer to enter thermal kill
*/
struct iwl_tt_mgmt {
enum iwl_tt_state state;