diff mbox series

[v10,1/2] Bluetooth: hci_qca: Add support for Qualcomm Bluetooth SoC QCA2066

Message ID 20230710055915.3290-1-quic_tjiang@quicinc.com
State New
Headers show
Series [v10,1/2] Bluetooth: hci_qca: Add support for Qualcomm Bluetooth SoC QCA2066 | expand

Commit Message

Tim Jiang July 10, 2023, 5:59 a.m. UTC
This patch adds support for QCA2066 firmware patch and NVM downloading.
as the RF performance of QCA2066 SOC chip from different foundries may
vary. Therefore we use different NVM to configure them based on board ID.

Signed-off-by: Tim Jiang <quic_tjiang@quicinc.com>
---
 drivers/bluetooth/btqca.c   | 76 ++++++++++++++++++++++++++++++++++++-
 drivers/bluetooth/btqca.h   |  4 ++
 drivers/bluetooth/hci_qca.c |  8 ++++
 3 files changed, 86 insertions(+), 2 deletions(-)

Comments

Johan Hovold July 10, 2023, 1:18 p.m. UTC | #1
On Mon, Jul 10, 2023 at 01:59:13PM +0800, Tim Jiang wrote:
> This patch adds support for QCA2066 firmware patch and NVM downloading.
> as the RF performance of QCA2066 SOC chip from different foundries may
> vary. Therefore we use different NVM to configure them based on board ID.
> 
> Signed-off-by: Tim Jiang <quic_tjiang@quicinc.com>
> ---

Again, there is still no changelog here describing what changed in each
revision of your patch as I've asked you to add. For example:

	Changes in v10
	 - break out ... into a separate patch
	 - ...
	Changes in v9
	 - ...
	...

When sending a series you should add a cover letter. The cover letter
should ideally contain the changelog for the whole series.

Also the two patches you have here should go in reverse order.

Johan
diff mbox series

Patch

diff --git a/drivers/bluetooth/btqca.c b/drivers/bluetooth/btqca.c
index e7e58a956d15..834b28706d90 100644
--- a/drivers/bluetooth/btqca.c
+++ b/drivers/bluetooth/btqca.c
@@ -205,6 +205,46 @@  static int qca_send_reset(struct hci_dev *hdev)
 	return 0;
 }
 
+static int qca_read_fw_board_id(struct hci_dev *hdev, u16 *bid)
+{
+	u8 cmd;
+	struct sk_buff *skb;
+	struct edl_event_hdr *edl;
+	int err = 0;
+	u8 bid_len;
+
+	cmd = EDL_GET_BID_REQ_CMD;
+	skb = __hci_cmd_sync_ev(hdev, EDL_PATCH_CMD_OPCODE, EDL_PATCH_CMD_LEN,
+				&cmd, 0, HCI_INIT_TIMEOUT);
+	if (IS_ERR(skb)) {
+		err = PTR_ERR(skb);
+		bt_dev_err(hdev, "Reading QCA board ID failed (%d)", err);
+		return err;
+	}
+
+	edl = skb_pull_data(skb, sizeof(*edl));
+	if (!edl) {
+		bt_dev_err(hdev, "QCA read board ID with no header");
+		err = -EILSEQ;
+		goto out;
+	}
+
+	if (edl->cresp != EDL_CMD_REQ_RES_EVT ||
+	    edl->rtype != EDL_GET_BID_REQ_CMD) {
+		bt_dev_err(hdev, "QCA Wrong packet: %d %d", edl->cresp, edl->rtype);
+		err = -EIO;
+		goto out;
+	}
+
+	bid_len = edl->data[0];
+	*bid = (edl->data[1] << 8) + edl->data[2];
+	bt_dev_dbg(hdev, "%s: bid len = %x, bid = %x", __func__, bid_len, *bid);
+
+out:
+	kfree_skb(skb);
+	return err;
+}
+
 int qca_send_pre_shutdown_cmd(struct hci_dev *hdev)
 {
 	struct sk_buff *skb;
@@ -574,6 +614,29 @@  int qca_set_bdaddr_rome(struct hci_dev *hdev, const bdaddr_t *bdaddr)
 }
 EXPORT_SYMBOL_GPL(qca_set_bdaddr_rome);
 
+static void qca_generate_nvm_name(struct hci_dev *hdev, char *fwname,
+		   size_t max_size, struct qca_btsoc_version ver, u16 bid)
+{
+	u8 rom_ver;
+	u32 soc_ver;
+	const char *variant;
+
+	soc_ver = get_soc_ver(ver.soc_id, ver.rom_ver);
+	rom_ver = ((soc_ver & 0x00000f00) >> 0x04) | (soc_ver & 0x0000000f);
+
+	if ((le32_to_cpu(ver.soc_id) & 0x0000ff00) == QCA_HSP_GF_SOC_ID)  /* hsp gf chip */
+		variant = "g";
+	else
+		variant = "";
+
+	if (bid == 0x0)
+		snprintf(fwname, max_size, "qca/hpnv%02x%s.bin", rom_ver, variant);
+	else
+		snprintf(fwname, max_size, "qca/hpnv%02x%s.%x", rom_ver, variant, bid);
+
+	bt_dev_dbg(hdev, "%s: nvm name is %s", __func__, fwname);
+}
+
 int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 		   enum qca_btsoc_type soc_type, struct qca_btsoc_version ver,
 		   const char *firmware_name)
@@ -582,6 +645,7 @@  int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 	int err;
 	u8 rom_ver = 0;
 	u32 soc_ver;
+	u16 boardid = 0;
 
 	bt_dev_dbg(hdev, "QCA setup on UART");
 
@@ -604,6 +668,9 @@  int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 	if (qca_is_wcn399x(soc_type)) {
 		snprintf(config.fwname, sizeof(config.fwname),
 			 "qca/crbtfw%02x.tlv", rom_ver);
+	} else if (soc_type == QCA_QCA2066) {
+		snprintf(config.fwname, sizeof(config.fwname),
+			 "qca/hpbtfw%02x.tlv", rom_ver);
 	} else if (soc_type == QCA_QCA6390) {
 		snprintf(config.fwname, sizeof(config.fwname),
 			 "qca/htbtfw%02x.tlv", rom_ver);
@@ -631,6 +698,9 @@  int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 	/* Give the controller some time to get ready to receive the NVM */
 	msleep(10);
 
+	if (soc_type == QCA_QCA2066)
+		qca_read_fw_board_id(hdev, &boardid);
+
 	/* Download NVM configuration */
 	config.type = TLV_TYPE_NVM;
 	if (firmware_name)
@@ -644,8 +714,10 @@  int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 			snprintf(config.fwname, sizeof(config.fwname),
 				 "qca/crnv%02x.bin", rom_ver);
 		}
-	}
-	else if (soc_type == QCA_QCA6390)
+	} else if (soc_type == QCA_QCA2066) {
+		qca_generate_nvm_name(hdev, config.fwname, sizeof(config.fwname),
+				ver, boardid);
+	} else if (soc_type == QCA_QCA6390)
 		snprintf(config.fwname, sizeof(config.fwname),
 			 "qca/htnv%02x.bin", rom_ver);
 	else if (soc_type == QCA_WCN6750)
diff --git a/drivers/bluetooth/btqca.h b/drivers/bluetooth/btqca.h
index b884095bcd9d..234a97a49bb9 100644
--- a/drivers/bluetooth/btqca.h
+++ b/drivers/bluetooth/btqca.h
@@ -13,6 +13,7 @@ 
 #define EDL_PATCH_TLV_REQ_CMD		(0x1E)
 #define EDL_GET_BUILD_INFO_CMD		(0x20)
 #define EDL_NVM_ACCESS_SET_REQ_CMD	(0x01)
+#define EDL_GET_BID_REQ_CMD		(0x23)
 #define EDL_PATCH_CONFIG_CMD		(0x28)
 #define MAX_SIZE_PER_TLV_SEGMENT	(243)
 #define QCA_PRE_SHUTDOWN_CMD		(0xFC08)
@@ -48,6 +49,8 @@ 
 
 #define QCA_FW_BUILD_VER_LEN		255
 
+#define QCA_HSP_GF_SOC_ID		0x1200
+
 
 enum qca_baudrate {
 	QCA_BAUDRATE_115200 	= 0,
@@ -148,6 +151,7 @@  enum qca_btsoc_type {
 	QCA_QCA6390,
 	QCA_WCN6750,
 	QCA_WCN6855,
+	QCA_QCA2066,
 };
 
 #if IS_ENABLED(CONFIG_BT_QCA)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 87a7325c75b1..c9774f7dbf24 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1748,6 +1748,7 @@  static int qca_setup(struct hci_uart *hu)
 	const char *firmware_name = qca_get_firmware_name(hu);
 	int ret;
 	struct qca_btsoc_version ver;
+	const char *soc_name;
 
 	ret = qca_check_speeds(hu);
 	if (ret)
@@ -1913,6 +1914,11 @@  static const struct qca_device_data qca_soc_data_qca6390 __maybe_unused = {
 	.num_vregs = 0,
 };
 
+static const struct qca_device_data qca_soc_data_qca2066 __maybe_unused = {
+	.soc_type = QCA_QCA2066,
+	.num_vregs = 0,
+};
+
 static const struct qca_device_data qca_soc_data_wcn6750 __maybe_unused = {
 	.soc_type = QCA_WCN6750,
 	.vregs = (struct qca_vreg []) {
@@ -2403,6 +2409,7 @@  static const struct of_device_id qca_bluetooth_of_match[] = {
 	{ .compatible = "qcom,wcn3998-bt", .data = &qca_soc_data_wcn3998},
 	{ .compatible = "qcom,wcn6750-bt", .data = &qca_soc_data_wcn6750},
 	{ .compatible = "qcom,wcn6855-bt", .data = &qca_soc_data_wcn6855},
+	{ .compatible = "qcom,qca2066-bt", .data = &qca_soc_data_qca2066},
 	{ /* sentinel */ }
 };
 MODULE_DEVICE_TABLE(of, qca_bluetooth_of_match);
@@ -2410,6 +2417,7 @@  MODULE_DEVICE_TABLE(of, qca_bluetooth_of_match);
 
 #ifdef CONFIG_ACPI
 static const struct acpi_device_id qca_bluetooth_acpi_match[] = {
+	{ "QCOM2066", (kernel_ulong_t)&qca_soc_data_qca2066 },
 	{ "QCOM6390", (kernel_ulong_t)&qca_soc_data_qca6390 },
 	{ "DLA16390", (kernel_ulong_t)&qca_soc_data_qca6390 },
 	{ "DLB16390", (kernel_ulong_t)&qca_soc_data_qca6390 },