| Message ID | 20230630092248.4146169-3-astrid.rost@axis.com |
|---|---|
| State | New |
| Headers | show |
| Series | [v2,1/2] led: led-class: Read max-brightness from devicetree | expand |
On Fri, Jun 30, 2023 at 11:22:47AM +0200, Astrid Rost wrote: > Add max-brightness in order to reduce the current on the connected LEDs. > Normally, the maximum brightness is determined by the hardware, and this > property is not required. This property is used to set a software limit. > It could happen that an LED is made so bright that it gets damaged or > causes damage due to restrictions in a specific system, such as mounting > conditions. Note that led-max-microamp should be preferably used, if it > is supported by the controller. > > Signed-off-by: Astrid Rost <astrid.rost@axis.com> > --- > Documentation/devicetree/bindings/leds/common.yaml | 10 ++++++++++ > 1 file changed, 10 insertions(+) The patch order is wrong. You have to define a property before you can use it. Otherwise, Reviewed-by: Rob Herring <robh@kernel.org>
diff --git a/Documentation/devicetree/bindings/leds/common.yaml b/Documentation/devicetree/bindings/leds/common.yaml index 11aedf1650a1..603a5630fc3d 100644 --- a/Documentation/devicetree/bindings/leds/common.yaml +++ b/Documentation/devicetree/bindings/leds/common.yaml @@ -160,6 +160,16 @@ properties: For flash LED controllers with configurable current this property is mandatory for the LEDs in the non-flash modes (e.g. torch or indicator). + max-brightness: + description: + Normally, the maximum brightness is determined by the hardware, and + this property is not required. This property is used to set a software + limit. It could happen that an LED is made so bright that it gets damaged + or causes damage due to restrictions in a specific system, such as + mounting conditions. Note that led-max-microamp should be preferably used, + if it is supported by the controller. + $ref: /schemas/types.yaml#definitions/uint32 + panic-indicator: description: This property specifies that the LED should be used, if at all possible,
Add max-brightness in order to reduce the current on the connected LEDs. Normally, the maximum brightness is determined by the hardware, and this property is not required. This property is used to set a software limit. It could happen that an LED is made so bright that it gets damaged or causes damage due to restrictions in a specific system, such as mounting conditions. Note that led-max-microamp should be preferably used, if it is supported by the controller. Signed-off-by: Astrid Rost <astrid.rost@axis.com> --- Documentation/devicetree/bindings/leds/common.yaml | 10 ++++++++++ 1 file changed, 10 insertions(+)