@@ -67,13 +67,13 @@ struct gpioline_info {
* @lineoffsets: an array desired lines, specified by offset index for the
* associated GPIO device
* @flags: desired flags for the desired GPIO lines, such as
- * GPIOLINE_IS_OUT, GPIOLINE_FLAG_ACTIVE_LOW etc, OR:ed together.
- * Note that even if multiple lines are requested, the same flags
+ * GPIOHANDLE_REQUEST_OUTPUT, GPIOHANDLE_REQUEST_ACTIVE_LOW etc, OR:ed
+ * together. Note that even if multiple lines are requested, the same flags
* must be applicable to all of them, if you want lines with individual
* flags set, request them one by one. It is possible to select
* a batch of input or output lines, but they must all have the same
* characteristics, i.e. all inputs or all outputs, all active low etc
- * @default_values: if the GPIOLINE_FLAG_IS_OUT is set for a requested
+ * @default_values: if the GPIOHANDLE_REQUEST_OUTPUT is set for a requested
* line, this specifies the default output value, should be 0 (low) or
* 1 (high), anything else than 0 or 1 will be interpreted as 1 (high)
* @consumer_label: a desired consumer label for the selected GPIO line(s)
The kerneldoc was referencing the wrong flag names from an earlier draft. Fix this up. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- include/uapi/linux/gpio.h | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) -- 2.4.11 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html