| Message ID | 20230419223323.20384-3-jm@ti.com |
|---|---|
| State | New |
| Headers | show |
| Series | None | expand |
On 20/04/2023 12:01, Marc Kleine-Budde wrote: > On 19.04.2023 17:33:21, Judith Mendez wrote: >> For MCAN, remove interrupt and interrupt names from the required >> section. >> >> On AM62x SoC, MCANs on MCU domain do not have hardware interrupt >> routed to A53 Linux, instead they will use software interrupt >> by hrtimer. Make interrupt attributes optional in MCAN node >> by removing from required section. >> >> Signed-off-by: Judith Mendez <jm@ti.com> > > This series basically adds polling support to the driver, which is > needed due to HW limitations. > > The proposed logic in the driver is to use polling if > platform_get_irq_byname() fails (due to whatever reason) use polling > with a hard-coded interval. > > In the kernel I've found the following properties that describe the > polling interval: > > bindings/input/input.yaml: > > | poll-interval: > | description: Poll interval time in milliseconds. > | $ref: /schemas/types.yaml#/definitions/uint32 > > > bindings/thermal/thermal-zones.yaml: > > | polling-delay: > | $ref: /schemas/types.yaml#/definitions/uint32 > | description: > | The maximum number of milliseconds to wait between polls when > | checking this thermal zone. Setting this to 0 disables the polling > | timers setup by the thermal framework and assumes that the thermal > | sensors in this zone support interrupts. > > bindings/regulator/dlg,da9121.yaml > > | dlg,irq-polling-delay-passive-ms: > | minimum: 1000 > | maximum: 10000 > | description: | > | Specify the polling period, measured in milliseconds, between interrupt status > | update checks. Range 1000-10000 ms. > > From my point of view the poll-interval from the input subsystem looks > good. Any objections to use it to specify the polling interval for > IRQ-less devices, too? Better to skip it, if delay can be figured out by driver based on something else (e.g. clocks). Best regards, Krzysztof
diff --git a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml index 67879aab623b..43f1aa9addc0 100644 --- a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml +++ b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml @@ -122,8 +122,6 @@ required: - compatible - reg - reg-names - - interrupts - - interrupt-names - clocks - clock-names - bosch,mram-cfg
For MCAN, remove interrupt and interrupt names from the required section. On AM62x SoC, MCANs on MCU domain do not have hardware interrupt routed to A53 Linux, instead they will use software interrupt by hrtimer. Make interrupt attributes optional in MCAN node by removing from required section. Signed-off-by: Judith Mendez <jm@ti.com> --- Documentation/devicetree/bindings/net/can/bosch,m_can.yaml | 2 -- 1 file changed, 2 deletions(-)