@@ -24,6 +24,8 @@ / {
aliases {
i2c4 = &i2c4;
i2c21 = &i2c21;
+ serial0 = &uart17;
+ serial1 = &uart2;
};
wcd938x: audio-codec {
@@ -297,6 +299,14 @@ pmc8280c-rpmh-regulators {
qcom,pmic-id = "c";
vdd-bob-supply = <&vreg_vph_pwr>;
+ vreg_s1c: smps1 {
+ regulator-name = "vreg_s1c";
+ regulator-min-microvolt = <1880000>;
+ regulator-max-microvolt = <1900000>;
+ regulator-allowed-modes = <RPMH_REGULATOR_MODE_AUTO>;
+ regulator-allow-set-load;
+ };
+
vreg_l1c: ldo1 {
regulator-name = "vreg_l1c";
regulator-min-microvolt = <1800000>;
@@ -712,6 +722,32 @@ &qup0 {
status = "okay";
};
+&uart2 {
+ status = "okay";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart2_state>;
+
+ bluetooth {
+ compatible = "qcom,wcn6855-bt";
+
+ vddio-supply = <&vreg_s10b>;
+ vddbtcxmx-supply = <&vreg_s12b>;
+ vddrfacmn-supply = <&vreg_s12b>;
+ vddrfa0p8-supply = <&vreg_s12b>;
+ vddrfa1p2-supply = <&vreg_s11b>;
+ vddrfa1p7-supply = <&vreg_s1c>;
+
+ max-speed = <3200000>;
+
+ enable-gpios = <&tlmm 133 GPIO_ACTIVE_HIGH>;
+ swctrl-gpios = <&tlmm 132 GPIO_ACTIVE_HIGH>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&bt_en>;
+ };
+};
+
&qup1 {
status = "okay";
};
@@ -720,6 +756,12 @@ &qup2 {
status = "okay";
};
+&uart17 {
+ compatible = "qcom,geni-debug-uart";
+
+ status = "okay";
+};
+
&remoteproc_adsp {
firmware-name = "qcom/sc8280xp/LENOVO/21BX/qcadsp8280.mbn";
@@ -980,6 +1022,19 @@ hastings_reg_en: hastings-reg-en-state {
&tlmm {
gpio-reserved-ranges = <70 2>, <74 6>, <83 4>, <125 2>, <128 2>, <154 7>;
+ bt_en: bt-en-state {
+ hstp-sw-ctrl-pins {
+ pins = "gpio132";
+ function = "gpio";
+ };
+
+ hstp-bt-en-pins {
+ pins = "gpio133";
+ function = "gpio";
+ drive-strength = <16>;
+ };
+ };
+
edp_reg_en: edp-reg-en-state {
pins = "gpio25";
function = "gpio";
@@ -1001,6 +1056,27 @@ i2c4_default: i2c4-default-state {
bias-disable;
};
+ uart2_state: uart2-state {
+ cts-pins {
+ pins = "gpio122";
+ function = "qup2";
+ bias-disable;
+ };
+
+ rts-tx-pins {
+ pins = "gpio122", "gpio123";
+ function = "qup2";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ rx-pins {
+ pins = "gpio124";
+ function = "qup2";
+ bias-pull-up;
+ };
+ };
+
i2c21_default: i2c21-default-state {
pins = "gpio81", "gpio82";
function = "qup21";
The Lenovo Thinkpad X13s has a WCN6855 Bluetooth controller on uart2, add this. Signed-off-by: Steev Klimaszewski <steev@kali.org> --- Changes since v3: * Add vreg_s1c * Add regulators and not dead code * Fix commit message changelog Changes since v2: * Remove dead code and add TODO comment * Make dtbs_check happy with the pin definitions --- .../qcom/sc8280xp-lenovo-thinkpad-x13s.dts | 76 +++++++++++++++++++ 1 file changed, 76 insertions(+)