@@ -23,6 +23,25 @@ aliases {
serial0 = &uart12;
};
+ wcd938x: codec {
+ compatible = "qcom,wcd9380-codec";
+ #sound-dai-cells = <1>;
+ reset-gpios = <&tlmm 32 GPIO_ACTIVE_LOW>;
+ vdd-buck-supply = <&vreg_s4a_1p8>;
+ vdd-rxtx-supply = <&vreg_s4a_1p8>;
+ vdd-io-supply = <&vreg_s4a_1p8>;
+ vdd-mic-bias-supply = <&vreg_bob>;
+ qcom,micbias1-microvolt = <1800000>;
+ qcom,micbias2-microvolt = <1800000>;
+ qcom,micbias3-microvolt = <1800000>;
+ qcom,micbias4-microvolt = <1800000>;
+ qcom,mbhc-buttons-vthreshold-microvolt = <75000 150000 237000 500000 500000 500000 500000 500000>;
+ qcom,mbhc-headset-vthreshold-microvolt = <1700000>;
+ qcom,mbhc-headphone-vthreshold-microvolt = <50000>;
+ qcom,rx-device = <&wcd_rx>;
+ qcom,tx-device = <&wcd_tx>;
+ };
+
chosen {
stdout-path = "serial0:115200n8";
};
@@ -631,27 +650,6 @@ &slpi {
firmware-name = "qcom/sm8250/slpi.mbn";
};
-&soc {
- wcd938x: codec {
- compatible = "qcom,wcd9380-codec";
- #sound-dai-cells = <1>;
- reset-gpios = <&tlmm 32 GPIO_ACTIVE_LOW>;
- vdd-buck-supply = <&vreg_s4a_1p8>;
- vdd-rxtx-supply = <&vreg_s4a_1p8>;
- vdd-io-supply = <&vreg_s4a_1p8>;
- vdd-mic-bias-supply = <&vreg_bob>;
- qcom,micbias1-microvolt = <1800000>;
- qcom,micbias2-microvolt = <1800000>;
- qcom,micbias3-microvolt = <1800000>;
- qcom,micbias4-microvolt = <1800000>;
- qcom,mbhc-buttons-vthreshold-microvolt = <75000 150000 237000 500000 500000 500000 500000 500000>;
- qcom,mbhc-headset-vthreshold-microvolt = <1700000>;
- qcom,mbhc-headphone-vthreshold-microvolt = <50000>;
- qcom,rx-device = <&wcd_rx>;
- qcom,tx-device = <&wcd_tx>;
- };
-};
-
&sound {
compatible = "qcom,sm8250-sndcard";
model = "SM8250-MTP-WCD9380-WSA8810-VA-DMIC";
The wcd938x codec is not a memory-mapped device and does not belong under the soc node. Move the node to the root node to avoid DT validation failures. Signed-off-by: Johan Hovold <johan+linaro@kernel.org> --- arch/arm64/boot/dts/qcom/sm8250-mtp.dts | 40 ++++++++++++------------- 1 file changed, 19 insertions(+), 21 deletions(-)