@@ -18,6 +18,7 @@ readonly V4_ADDR1=10.0.10.2
readonly V6_ADDR0=2001:db8:91::1
readonly V6_ADDR1=2001:db8:91::2
nsid=100
+ret=0
cleanup_v6()
{
@@ -61,7 +62,7 @@ setup_v6() {
if [ $? -ne 0 ]; then
cleanup_v6
echo "failed"
- exit
+ exit 1
fi
# Set veth2 down, which will put veth1 in NOCARRIER state
@@ -88,7 +89,7 @@ setup_v4() {
if [ $? -ne 0 ]; then
cleanup_v4
echo "failed"
- exit
+ exit 1
fi
# Set veth1 down, which will put veth0 in NOCARRIER state
@@ -115,6 +116,7 @@ run_arp_evict_nocarrier_enabled() {
if [ $? -eq 0 ];then
echo "failed"
+ ret=1
else
echo "ok"
fi
@@ -134,6 +136,7 @@ run_arp_evict_nocarrier_disabled() {
echo "ok"
else
echo "failed"
+ ret=1
fi
cleanup_v4
@@ -164,6 +167,7 @@ run_ndisc_evict_nocarrier_enabled() {
if [ $? -eq 0 ];then
echo "failed"
+ ret=1
else
echo "ok"
fi
@@ -182,6 +186,7 @@ run_ndisc_evict_nocarrier_disabled() {
echo "ok"
else
echo "failed"
+ ret=1
fi
cleanup_v6
@@ -198,6 +203,7 @@ run_ndisc_evict_nocarrier_disabled_all() {
echo "ok"
else
echo "failed"
+ ret=1
fi
cleanup_v6
@@ -218,3 +224,4 @@ if [ "$(id -u)" -ne 0 ];then
fi
run_all_tests
+exit $ret
Return non-zero return value if there is any failure reported in this script during the test. Otherwise it can only reflect the status of the last command. Fixes: f86ca07eb531 ("selftests: net: add arp_ndisc_evict_nocarrier") Signed-off-by: Po-Hsu Lin <po-hsu.lin@canonical.com> --- tools/testing/selftests/net/arp_ndisc_evict_nocarrier.sh | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-)