@@ -741,9 +741,13 @@
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x16>;
- ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
+ ranges = <0 0 0x08000000 0x01000000>; /* minimum GPMC partition = 16MB */
nand@0,0 {
+ compatible = "ti,omap2-nand";
reg = <0 0 4>; /* device IO registers */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
@@ -1438,6 +1438,8 @@
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
status = "disabled";
};
@@ -492,13 +492,17 @@
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_default>;
- ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
+ ranges = <0 0 0x08000000 0x01000000>; /* minimum GPMC partition = 16MB */
nand@0,0 {
/* To use NAND, DIP switch SW5 must be set like so:
* SW5.1 (NAND_SELn) = ON (LOW)
* SW5.9 (GPMC_WPN) = OFF (HIGH)
*/
+ compatible = "ti,omap2-nand";
reg = <0 0 4>; /* device IO registers */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
Add compatible id, GPMC register resource and interrupt resource to NAND controller nodes. The GPMC node will provide an interrupt controller for the NAND IRQs. Signed-off-by: Roger Quadros <rogerq@ti.com> --- arch/arm/boot/dts/dra7-evm.dts | 6 +++++- arch/arm/boot/dts/dra7.dtsi | 2 ++ arch/arm/boot/dts/dra72-evm.dts | 6 +++++- 3 files changed, 12 insertions(+), 2 deletions(-) -- 2.5.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html