@@ -748,6 +748,7 @@
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
+ rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 pin */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
@@ -503,6 +503,7 @@
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
+ rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 pin */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
On these boards NAND ready pin status is avilable over GPMC_WAIT0 pin. Read speed increases from 13768 KiB/ to 17246 KiB/s. Write speed was unchanged at 7123 KiB/s. Measured using mtd_speedtest.ko. Signed-off-by: Roger Quadros <rogerq@ti.com> --- arch/arm/boot/dts/dra7-evm.dts | 1 + arch/arm/boot/dts/dra72-evm.dts | 1 + 2 files changed, 2 insertions(+) -- 2.1.4