diff mbox series

[v2] thermal: imx8mm_thermal: wait for a valid measurement

Message ID 20221007073057.41803-1-marcus.folkesson@gmail.com
State New
Headers show
Series [v2] thermal: imx8mm_thermal: wait for a valid measurement | expand

Commit Message

Marcus Folkesson Oct. 7, 2022, 7:30 a.m. UTC
Check if first measurement is still pending or if temperature is out of
range.
Return and try again later if that is the case.

Fixes: 5eed800a6811 ("thermal: imx8mm: Add support for i.MX8MM thermal monitoring unit")
Signed-off-by: Marcus Folkesson <marcus.folkesson@gmail.com>
---

Notes:
    v2: Also invalidate if temperature > max (125 degrees C)

 drivers/thermal/imx8mm_thermal.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

Comments

Marcus Folkesson Oct. 14, 2022, 7:28 a.m. UTC | #1
Hi Peng,

On Fri, Oct 14, 2022 at 09:20:21AM +0800, Peng Fan wrote:
> 
> 
> On 10/7/2022 3:30 PM, Marcus Folkesson wrote:
> > Check if first measurement is still pending or if temperature is out of
> > range.
> > Return and try again later if that is the case.
> > 
> > Fixes: 5eed800a6811 ("thermal: imx8mm: Add support for i.MX8MM thermal monitoring unit")
> > Signed-off-by: Marcus Folkesson <marcus.folkesson@gmail.com>
> 
> NAK:
> Please refer: https://www.nxp.com/docs/en/errata/IMX8MM_0N87W.pdf
> ERR051272: TMU: Bit 31 of registers TMU_TSCR/TMU_TRITSR/TMU_TRATSR invalid

I see, thank you.

I think it is still worth to check the upper limit though, so I will
send a patch for that.

> 
> Thanks,
> Peng.

Best regards,
Marcus Folkesson
diff mbox series

Patch

diff --git a/drivers/thermal/imx8mm_thermal.c b/drivers/thermal/imx8mm_thermal.c
index af666bd9e8d4..e42bf373cebc 100644
--- a/drivers/thermal/imx8mm_thermal.c
+++ b/drivers/thermal/imx8mm_thermal.c
@@ -62,11 +62,17 @@  static int imx8mm_tmu_get_temp(void *data, int *temp)
 {
 	struct tmu_sensor *sensor = data;
 	struct imx8mm_tmu *tmu = sensor->priv;
-	u32 val;
+	bool ready;
+	unsigned long val;
+
+	val = readl_relaxed(tmu->base + TRITSR);
+	ready = test_bit(probe_status_offset(1), &val);
+	if (!ready)
+		return -EAGAIN;
 
-	val = readl_relaxed(tmu->base + TRITSR) & TRITSR_TEMP0_VAL_MASK;
+	val = val & TRITSR_TEMP0_VAL_MASK;
 	*temp = val * 1000;
-	if (*temp < VER1_TEMP_LOW_LIMIT)
+	if (*temp < VER1_TEMP_LOW_LIMIT || *temp > VER2_TEMP_HIGH_LIMIT)
 		return -EAGAIN;
 
 	return 0;