@@ -282,40 +282,25 @@ &remoteproc_mpss {
};
&tlmm {
- pcie_ep_clkreq_default: pcie_ep_clkreq_default {
- mux {
- pins = "gpio56";
- function = "pcie_clkreq";
- };
- config {
- pins = "gpio56";
- drive-strength = <2>;
- bias-disable;
- };
+ pcie_ep_clkreq_default: pcie-ep-clkreq-default-state {
+ pins = "gpio56";
+ function = "pcie_clkreq";
+ drive-strength = <2>;
+ bias-disable;
};
- pcie_ep_perst_default: pcie_ep_perst_default {
- mux {
- pins = "gpio57";
- function = "gpio";
- };
- config {
- pins = "gpio57";
- drive-strength = <2>;
- bias-pull-down;
- };
+ pcie_ep_perst_default: pcie-ep-perst-default-state {
+ pins = "gpio57";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
};
- pcie_ep_wake_default: pcie_ep_wake_default {
- mux {
- pins = "gpio53";
- function = "gpio";
- };
- config {
- pins = "gpio53";
- drive-strength = <2>;
- bias-disable;
- };
+ pcie_ep_wake_default: pcie-ep-wake-default-state {
+ pins = "gpio53";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
};
};
DT schema expects TLMM pin configuration nodes to be named with '-state' suffix and their optional children with '-pins' suffix. Schema also requires 'function' property, so two nodes for the same gpio (mux and config) should be merged into one. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- .../boot/dts/qcom-sdx55-telit-fn980-tlb.dts | 45 +++++++------------ 1 file changed, 15 insertions(+), 30 deletions(-)