@@ -604,7 +604,6 @@ struct lpfc_vport {
#define FC_VFI_REGISTERED 0x800000 /* VFI is registered */
#define FC_FDISC_COMPLETED 0x1000000/* FDISC completed */
#define FC_DISC_DELAYED 0x2000000/* Delay NPort discovery */
-#define FC_RSCN_MEMENTO 0x4000000/* RSCN cmd processed */
uint32_t ct_flags;
#define FC_CT_RFF_ID 0x1 /* RFF_ID accepted by switch */
@@ -1887,7 +1887,6 @@ lpfc_end_rscn(struct lpfc_vport *vport)
else {
spin_lock_irq(shost->host_lock);
vport->fc_flag &= ~FC_RSCN_MODE;
- vport->fc_flag |= FC_RSCN_MEMENTO;
spin_unlock_irq(shost->host_lock);
}
}
@@ -2435,14 +2434,13 @@ lpfc_issue_els_prli(struct lpfc_vport *vport, struct lpfc_nodelist *ndlp,
u32 local_nlp_type, elscmd;
/*
- * If discovery was kicked off from RSCN mode,
- * the FC4 types supported from a
+ * If we are in RSCN mode, the FC4 types supported from a
* previous GFT_ID command may not be accurate. So, if we
* are a NVME Initiator, always look for the possibility of
* the remote NPort beng a NVME Target.
*/
if (phba->sli_rev == LPFC_SLI_REV4 &&
- vport->fc_flag & (FC_RSCN_MODE | FC_RSCN_MEMENTO) &&
+ vport->fc_flag & FC_RSCN_MODE &&
vport->nvmei_support)
ndlp->nlp_fc4_type |= NLP_FC4_NVME;
local_nlp_type = ndlp->nlp_fc4_type;
@@ -7916,7 +7914,6 @@ lpfc_els_rcv_rscn(struct lpfc_vport *vport, struct lpfc_iocbq *cmdiocb,
if ((rscn_cnt < FC_MAX_HOLD_RSCN) &&
!(vport->fc_flag & FC_RSCN_DISCOVERY)) {
vport->fc_flag |= FC_RSCN_MODE;
- vport->fc_flag &= ~FC_RSCN_MEMENTO;
spin_unlock_irq(shost->host_lock);
if (rscn_cnt) {
cmd = vport->fc_rscn_id_list[rscn_cnt-1]->virt;
@@ -7966,7 +7963,6 @@ lpfc_els_rcv_rscn(struct lpfc_vport *vport, struct lpfc_iocbq *cmdiocb,
spin_lock_irq(shost->host_lock);
vport->fc_flag |= FC_RSCN_MODE;
- vport->fc_flag &= ~FC_RSCN_MEMENTO;
spin_unlock_irq(shost->host_lock);
vport->fc_rscn_id_list[vport->fc_rscn_id_cnt++] = pcmd;
/* Indicate we are done walking fc_rscn_id_list on this vport */
@@ -1354,8 +1354,7 @@ lpfc_linkup_port(struct lpfc_vport *vport)
spin_lock_irq(shost->host_lock);
vport->fc_flag &= ~(FC_PT2PT | FC_PT2PT_PLOGI | FC_ABORT_DISCOVERY |
- FC_RSCN_MEMENTO | FC_RSCN_MODE |
- FC_NLP_MORE | FC_RSCN_DISCOVERY);
+ FC_RSCN_MODE | FC_NLP_MORE | FC_RSCN_DISCOVERY);
vport->fc_flag |= FC_NDISC_ACTIVE;
vport->fc_ns_retry = 0;
spin_unlock_irq(shost->host_lock);
The RSCN_MEMENTO logic was to workaround a target that does not register both FCP and NVME FC4 types at the same time. This caused the configuration to not produce a second RSCN for the NVME FC4 type registration in a timely manner. The intention of the RSCN_MEMENTO flag was to always signal to try NVME PRLI. However, there are other FCP-only target arrays in correctly behaved configurations that reject the NVME PRLI followed by a LOGO leading to never rediscovering the target after an issue_lip (as LOGO causes a repeat of PLOGI/PRLIs). Revert the RSCN_MEMENTO patch as it is causing correctly behaved configs to fail while it exists only to succeed on a misbehaved config. Fixes: 1045592fc968 ("scsi: lpfc: Introduce FC_RSCN_MEMENTO flag for tracking post RSCN completion") Co-developed-by: Justin Tee <justin.tee@broadcom.com> Signed-off-by: Justin Tee <justin.tee@broadcom.com> Signed-off-by: James Smart <jsmart2021@gmail.com> --- drivers/scsi/lpfc/lpfc.h | 1 - drivers/scsi/lpfc/lpfc_els.c | 8 ++------ drivers/scsi/lpfc/lpfc_hbadisc.c | 3 +-- 3 files changed, 3 insertions(+), 9 deletions(-)