@@ -381,6 +381,58 @@ Add device @var{driver}. @var{prop}=@var{value} sets driver
properties. Valid properties depend on the driver. To get help on
possible drivers and properties, use @code{-device help} and
@code{-device @var{driver},help}.
+
+Some drivers are:
+@item -device ipmi-bmc-sim,id=@var{id}[,slave_addr=@var{val}]
+
+Add an IPMI BMC. This is a simulation of a hardware management
+interface processor that normally sits on a system. It provides
+a watchdog and the ability to reset and power control the system.
+You need to connect this to an IPMI interface to make it useful
+
+The IPMI slave address to use for the BMC. The default is 0x20.
+This address is the BMC's address on the I2C network of management
+controllers. If you don't know what this means, it is safe to ignore
+it.
+
+@item -device ipmi-bmc-extern,id=@var{id},chardev=@var{id}[,slave_addr=@var{val}]
+
+Add a connection to an external IPMI BMC simulator. Instead of
+locally emulating the BMC like the above item, instead connect
+to an external entity that provides the IPMI services.
+
+A connection is made to an external BMC simulator. If you do this, it
+is strongly recommended that you use the "reconnect=" chardev option
+to reconnect to the simulator if the connection is lost. Note that if
+this is not used carefully, it can be a security issue, as the
+interface has the ability to send resets, NMIs, and power off the VM.
+It's best if QEMU makes a connection to an external simulator running
+on a secure port on localhost, so neither the simulator nor QEMU is
+exposed to any outside network.
+
+See the "lanserv/README.vm" file in the OpenIPMI library for more
+details on the external interface.
+
+@item -device isa-ipmi-kcs,bmc=@var{id}[,ioport=@var{val}][,irq=@var{val}]
+
+Add a KCS IPMI interafce on the ISA bus. This also adds a
+corresponding ACPI and SMBIOS entries, if appropriate.
+
+@table @option
+@item bmc=@var{id}
+The BMC to connect to, one of ipmi-bmc-sim or ipmi-bmc-extern above.
+@item ioport=@var{val}
+Define the I/O address of the interface. The default is 0xca0 for KCS.
+@item irq=@var{val}
+Define the interrupt to use. The default is 5. To disable interrupts,
+set this to 0.
+@end table
+
+@item -device isa-ipmi-bt,bmc=@var{id}[,ioport=@var{val}][,irq=@var{val}]
+
+Like the KCS interface, but defines a BT interface. The default port is
+0xe4 and the default interrupt is 5.
+
ETEXI
DEF("name", HAS_ARG, QEMU_OPTION_name,