@@ -702,6 +702,11 @@ static struct uart_driver ar933x_uart_driver = {
.cons = NULL, /* filled in runtime */
};
+static const struct serial_rs485 ar933x_no_rs485 = {};
+static const struct serial_rs485 ar933x_rs485_supported = {
+ .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND,
+};
+
static int ar933x_uart_probe(struct platform_device *pdev)
{
struct ar933x_uart_port *up;
@@ -773,6 +778,7 @@ static int ar933x_uart_probe(struct platform_device *pdev)
port->fifosize = AR933X_UART_FIFO_SIZE;
port->ops = &ar933x_uart_ops;
port->rs485_config = ar933x_config_rs485;
+ port->rs485_supported = &ar933x_rs485_supported;
baud = ar933x_uart_get_baud(port->uartclk, AR933X_UART_MAX_SCALE, 1);
up->min_baud = max_t(unsigned int, baud, AR933X_UART_MIN_BAUD);
@@ -796,6 +802,7 @@ static int ar933x_uart_probe(struct platform_device *pdev)
!up->rts_gpiod) {
dev_err(&pdev->dev, "lacking rts-gpio, disabling RS485\n");
port->rs485.flags &= ~SER_RS485_ENABLED;
+ port->rs485_supported = &ar933x_no_rs485;
}
#ifdef CONFIG_SERIAL_AR933X_CONSOLE
Add information on supported serial_rs485 features. In the case where RTS is lacking, RS485 cannot be enabled so provide zero rs485_supported for that case. Perhaps it would make sense to not provide rs485_config() at all in that case but such a change would have userspace visible impact/change in behavior so this patch does not attempt it. Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com> --- drivers/tty/serial/ar933x_uart.c | 7 +++++++ 1 file changed, 7 insertions(+)