diff mbox series

[7/7] arm64: dts: qcom: sm6125-seine: Configure additional trinket thermistors

Message ID 20220511220613.1015472-8-marijn.suijten@somainline.org
State Superseded
Headers show
Series None | expand

Commit Message

Marijn Suijten May 11, 2022, 10:06 p.m. UTC 
In addition to PMIC-specific (pm6125) thermistors downstream extends
this set with the rf-pa0/rf-pa1, quiet, camera-flash and UFS/eMMC
thermistors in sm6125 (trinket) board and seine-specific DT files.  All
thermistors report sensible temperature readings in userspace.

The sensors are also added to their respective Thermal Monitor node,
with thermal zones to match where applicable: emmc-ufs and camera-flash
are not available on the TM5 block, hence cannot be configured with a
tripping point and will not have a thermal zone.

Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@somainline.org>
---
 .../qcom/sm6125-sony-xperia-seine-pdx201.dts  | 150 ++++++++++++++++++
 1 file changed, 150 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sm6125-sony-xperia-seine-pdx201.dts b/arch/arm64/boot/dts/qcom/sm6125-sony-xperia-seine-pdx201.dts
index c5967140d028..ca7f074a62a9 100644
--- a/arch/arm64/boot/dts/qcom/sm6125-sony-xperia-seine-pdx201.dts
+++ b/arch/arm64/boot/dts/qcom/sm6125-sony-xperia-seine-pdx201.dts
@@ -82,12 +82,162 @@  cmdline_mem: memory@ffd00000 {
 			no-map;
 		};
 	};
+
+	thermal-zones {
+		rf-pa0-thermal {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm6125_adc_tm 0>;
+
+			trips {
+				active-config0 {
+					temperature = <125000>;
+					hysteresis = <1000>;
+					type = "critical";
+				};
+			};
+		};
+
+		quiet-thermal {
+			polling-delay-passive = <0>;
+			polling-delay = <5000>;
+			thermal-sensors = <&pm6125_adc_tm 1>;
+
+			trips {
+				active-config0 {
+					temperature = <125000>;
+					hysteresis = <1000>;
+					type = "critical";
+				};
+			};
+		};
+
+		xo-thermal {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm6125_adc_tm 2>;
+
+			trips {
+				active-config0 {
+					temperature = <125000>;
+					hysteresis = <1000>;
+					type = "critical";
+				};
+			};
+		};
+
+		rf-pa1-thermal {
+			polling-delay-passive = <0>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm6125_adc_tm 3>;
+
+			trips {
+				active-config0 {
+					temperature = <125000>;
+					hysteresis = <1000>;
+					type = "critical";
+				};
+			};
+		};
+	};
 };
 
 &hsusb_phy1 {
 	status = "okay";
 };
 
+&pm6125_adc {
+	pinctrl-names = "default";
+	pinctrl-0 = <&camera_flash_therm &emmc_ufs_therm &rf_pa1_therm>;
+
+	rf-pa0-therm@4d {
+		reg = <ADC5_AMUX_THM1_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+		qcom,pre-scaling = <1 1>;
+	};
+
+	quiet-therm@4e {
+		reg = <ADC5_AMUX_THM2_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+		qcom,pre-scaling = <1 1>;
+	};
+
+	camera-flash-therm@52 {
+		reg = <ADC5_GPIO1_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+		qcom,pre-scaling = <1 1>;
+	};
+
+	emmc-ufs-therm@54 {
+		reg = <ADC5_GPIO3_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+		qcom,pre-scaling = <1 1>;
+	};
+
+	rf-pa1-therm@55 {
+		reg = <ADC5_GPIO4_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+		qcom,pre-scaling = <1 1>;
+	};
+};
+
+&pm6125_adc_tm {
+	status = "okay";
+
+	rf-pa0-therm@0 {
+		reg = <0>;
+		io-channels = <&pm6125_adc ADC5_AMUX_THM1_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+	};
+
+	quiet-therm@1 {
+		reg = <1>;
+		io-channels = <&pm6125_adc ADC5_AMUX_THM2_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+	};
+
+	xo-therm@2 {
+		reg = <2>;
+		io-channels = <&pm6125_adc ADC5_XO_THERM_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+	};
+
+	rf-pa1-therm@3 {
+		reg = <3>;
+		io-channels = <&pm6125_adc ADC5_GPIO4_100K_PU>;
+		qcom,ratiometric;
+		qcom,hw-settle-time = <200>;
+	};
+};
+
+&pm6125_gpio {
+	camera_flash_therm: camera-flash-therm {
+		pins = "gpio3";
+		function = "normal";
+		bias-high-impedance;
+	};
+
+	emmc_ufs_therm: emmc-ufs-therm {
+		pins = "gpio6";
+		function = "normal";
+		bias-high-impedance;
+	};
+
+	rf_pa1_therm: rf-pa1-therm {
+		pins = "gpio7";
+		function = "normal";
+		bias-high-impedance;
+	};
+};
+
 &pon_pwrkey {
 	status = "okay";
 };