@@ -586,16 +586,15 @@ int dwc3_drd_init(struct dwc3 *dwc)
{
int ret, irq;
+ if (ROLE_SWITCH &&
+ device_property_read_bool(dwc->dev, "usb-role-switch"))
+ return dwc3_setup_role_switch(dwc);
+
dwc->edev = dwc3_get_extcon(dwc);
if (IS_ERR(dwc->edev))
return PTR_ERR(dwc->edev);
- if (ROLE_SWITCH &&
- device_property_read_bool(dwc->dev, "usb-role-switch")) {
- ret = dwc3_setup_role_switch(dwc);
- if (ret < 0)
- return ret;
- } else if (dwc->edev) {
+ if (dwc->edev) {
dwc->edev_nb.notifier_call = dwc3_drd_notifier;
ret = extcon_register_notifier(dwc->edev, EXTCON_USB_HOST,
&dwc->edev_nb);
If the PHY controller node has a "port" dwc3 tries to find an extcon device even when "usb-role-switch" is present. This happens because dwc3_get_extcon() sees that "port" node and then calls extcon_find_edev_by_node() which will always return EPROBE_DEFER in that case. On the other hand, even if an extcon was present and dwc3_get_extcon() was successful it would still be ignored in favor of "usb-role-switch". Let's just first check if "usb-role-switch" is configured in the device tree and directly use it instead and only try to look for an extcon device otherwise. Fixes: 8a0a13799744 ("usb: dwc3: Registering a role switch in the DRD code.") Signed-off-by: Sven Peter <sven@svenpeter.dev> --- drivers/usb/dwc3/drd.c | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-)