@@ -2368,18 +2368,28 @@ static int pl011_probe(struct amba_device *dev, const struct amba_id *id)
if (!uap)
return -ENOMEM;
- uap->clk = devm_clk_get(&dev->dev, NULL);
- if (IS_ERR(uap->clk))
- return PTR_ERR(uap->clk);
-
- uap->vendor = vendor;
- uap->lcrh_rx = vendor->lcrh_rx;
- uap->lcrh_tx = vendor->lcrh_tx;
- uap->fifosize = vendor->get_fifosize(dev);
+ /* ACPI only defines SBSA variant */
+ if (!ACPI_COMPANION(&dev->dev)) {
+ uap->clk = devm_clk_get(&dev->dev, NULL);
+ if (IS_ERR(uap->clk))
+ return PTR_ERR(uap->clk);
+
+ uap->vendor = vendor;
+ uap->lcrh_rx = vendor->lcrh_rx;
+ uap->lcrh_tx = vendor->lcrh_tx;
+ uap->fifosize = vendor->get_fifosize(dev);
+ uap->port.ops = &amba_pl011_pops;
+ snprintf(uap->type, sizeof(uap->type), "PL011 rev%u",
+ amba_rev(dev));
+ } else {
+ uap->vendor = &vendor_sbsa;
+ uap->fifosize = 32;
+ uap->port.ops = &sbsa_uart_pops;
+ uap->fixed_baud = 115200;
+
+ snprintf(uap->type, sizeof(uap->type), "SBSA");
+ }
uap->port.irq = dev->irq[0];
- uap->port.ops = &amba_pl011_pops;
-
- snprintf(uap->type, sizeof(uap->type), "PL011 rev%u", amba_rev(dev));
ret = pl011_setup_port(&dev->dev, uap, &dev->res, portnr);
if (ret)
In ACPI this device is only defined in SBSA mode so if we are probing from ACPI use this mode. Cc: Rafael J. Wysocki <rjw@rjwysocki.net> Cc: Len Brown <lenb@kernel.org> Cc: Russell King <linux@arm.linux.org.uk> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Signed-off-by: Graeme Gregory <graeme.gregory@linaro.org> --- drivers/tty/serial/amba-pl011.c | 32 +++++++++++++++++++++----------- 1 file changed, 21 insertions(+), 11 deletions(-)