diff mbox series

[5.16,0718/1039] net: phy: marvell: configure RGMII delays for 88E1118

Message ID 20220124184149.464977724@linuxfoundation.org
State New
Headers show
Series None | expand

Commit Message

Greg KH Jan. 24, 2022, 6:41 p.m. UTC 
From: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>

[ Upstream commit f22725c95ececb703c3f741e8f946d23705630b7 ]

Corentin Labbe reports that the SSI 1328 does not work when allowing
the PHY to operate at gigabit speeds, but does work with the generic
PHY driver.

This appears to be because m88e1118_config_init() writes a fixed value
to the MSCR register, claiming that this is to enable 1G speeds.
However, this always sets bits 4 and 5, enabling RGMII transmit and
receive delays. The suspicion is that the original board this was
added for required the delays to make 1G speeds work.

Add the necessary configuration for RGMII delays for the 88E1118 to
bring this into line with the requirements for RGMII support, and thus
make the SSI 1328 work.

Corentin Labbe has tested this on gemini-ssi1328 and gemini-ns2502.

Reported-by: Corentin Labbe <clabbe.montjoie@gmail.com>
Tested-by: Corentin Labbe <clabbe.montjoie@gmail.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/net/phy/marvell.c |    6 ++++++
 1 file changed, 6 insertions(+)
diff mbox series

Patch

--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -1244,6 +1244,12 @@  static int m88e1118_config_init(struct p
 	if (err < 0)
 		return err;
 
+	if (phy_interface_is_rgmii(phydev)) {
+		err = m88e1121_config_aneg_rgmii_delays(phydev);
+		if (err < 0)
+			return err;
+	}
+
 	/* Adjust LED Control */
 	if (phydev->dev_flags & MARVELL_PHY_M1118_DNS323_LEDS)
 		err = phy_write(phydev, 0x10, 0x1100);