[v3] serial: pch_uart: potential dereference of null pointer

The return value of dma_alloc_coherent() needs to be checked.
To avoid dereference of null pointer in case of the failure of alloc.
Signed-off-by: Jiasheng Jiang <jiasheng@iscas.ac.cn>
---
Changelog:

v2 -> v3

*Change 1. Remove dev_err.
*Change 2. Change the return type of pch_request_dma to int.
*Change 3. Return -ENOMEM when dma_alloc_coherent() failed and 0 the
others.
*Change 4. Check return value of dma_alloc_coherent().
---
 drivers/tty/serial/pch_uart.c | 25 +++++++++++++++++++------
 1 file changed, 19 insertions(+), 6 deletions(-)

On Thu, Dec 16, 2021 at 10:14:54PM +0800, Jiasheng Jiang wrote:
> The return value of dma_alloc_coherent() needs to be checked.
> To avoid dereference of null pointer in case of the failure of alloc.
> Signed-off-by: Jiasheng Jiang <jiasheng@iscas.ac.cn>
> ---
> Changelog:
> 
> v2 -> v3
> 
> *Change 1. Remove dev_err.
> *Change 2. Change the return type of pch_request_dma to int.
> *Change 3. Return -ENOMEM when dma_alloc_coherent() failed and 0 the
> others.
> *Change 4. Check return value of dma_alloc_coherent().
> ---
>  drivers/tty/serial/pch_uart.c | 25 +++++++++++++++++++------
>  1 file changed, 19 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/tty/serial/pch_uart.c b/drivers/tty/serial/pch_uart.c
> index f0351e6f0ef6..cfad5592010c 100644
> --- a/drivers/tty/serial/pch_uart.c
> +++ b/drivers/tty/serial/pch_uart.c
> @@ -698,7 +698,7 @@ static bool filter(struct dma_chan *chan, void *slave)
>  	}
>  }
>  
> -static void pch_request_dma(struct uart_port *port)
> +static int pch_request_dma(struct uart_port *port)
>  {
>  	dma_cap_mask_t mask;
>  	struct dma_chan *chan;
> @@ -723,7 +723,7 @@ static void pch_request_dma(struct uart_port *port)
>  	if (!chan) {
>  		dev_err(priv->port.dev, "%s:dma_request_channel FAILS(Tx)\n",
>  			__func__);
> -		return;
> +		return 0;
>  	}
>  	priv->chan_tx = chan;
>  
> @@ -739,13 +739,20 @@ static void pch_request_dma(struct uart_port *port)
>  			__func__);
>  		dma_release_channel(priv->chan_tx);
>  		priv->chan_tx = NULL;
> -		return;
> +		return 0;
>  	}
>  
>  	/* Get Consistent memory for DMA */
>  	priv->rx_buf_virt = dma_alloc_coherent(port->dev, port->fifosize,
>  				    &priv->rx_buf_dma, GFP_KERNEL);
> +	if (!priv->rx_buf_virt) {
> +		dma_release_channel(priv->chan_tx);
> +		priv->chan_tx = NULL;
> +		return -ENOMEM;
> +	}
> +
>  	priv->chan_rx = chan;
> +	return 0;
>  }
>  
>  static void pch_dma_rx_complete(void *arg)
> @@ -1321,8 +1328,11 @@ static int pch_uart_startup(struct uart_port *port)
>  	if (ret < 0)
>  		return ret;
>  
> -	if (priv->use_dma)
> -		pch_request_dma(port);
> +	if (priv->use_dma) {
> +		ret = pch_request_dma(port);
> +		if (ret)
> +			return ret;
> +	}
>  
>  	priv->start_rx = 1;
>  	pch_uart_hal_enable_interrupt(priv, PCH_UART_HAL_RX_INT |
> @@ -1469,6 +1479,7 @@ static int pch_uart_verify_port(struct uart_port *port,
>  				struct serial_struct *serinfo)
>  {
>  	struct eg20t_port *priv;
> +	int ret;
>  
>  	priv = container_of(port, struct eg20t_port, port);
>  	if (serinfo->flags & UPF_LOW_LATENCY) {
> @@ -1483,7 +1494,9 @@ static int pch_uart_verify_port(struct uart_port *port,
>  		return -EOPNOTSUPP;
>  #endif
>  		if (!priv->use_dma) {
> -			pch_request_dma(port);
> +			ret = pch_request_dma(port);
> +			if (ret)
> +				return ret;
>  			if (priv->chan_rx)
>  				priv->use_dma = 1;
>  		}
> -- 
> 2.25.1
> 

This patch is obviously not correct, and will cause problems if it were
accepted.

Please work on whatever tool you are using to find and make these
changes, as it is not working properly.

Or, if this was a manual change, please work on your kernel programming
skills.  There are a number of bugs in this proposed change, showing
that it was not tested at all.

thanks,

greg k-h