@@ -2500,7 +2500,8 @@ s3c24xx_serial_console_write(struct console *co, const char *s,
uart_console_write(cons_uart, s, count, s3c24xx_serial_console_putchar);
}
-static void __init
+/* Shouldn't be __init, as it can be instantiated from other module */
+static void
s3c24xx_serial_get_options(struct uart_port *port, int *baud,
int *parity, int *bits)
{
@@ -2563,7 +2564,8 @@ s3c24xx_serial_get_options(struct uart_port *port, int *baud,
}
}
-static int __init
+/* Shouldn't be __init, as it can be instantiated from other module */
+static int
s3c24xx_serial_console_setup(struct console *co, char *options)
{
struct uart_port *port;
On modern Exynos SoCs (like Exynos850) the UART can be implemented as a part of USI IP-core. In such case, USI driver is used to initialize USI registers, and it also calls of_platform_populate() to instantiate all sub-nodes (e.g. serial node) of USI node. When serial driver is built-in, but USI driver is a module, and CONFIG_SERIAL_SAMSUNG_CONSOLE is enabled, next call chain will happen when loading USI module from user space: usi_init v usi_probe v of_platform_populate v s3c24xx_serial_probe v uart_add_one_port v uart_configure_port v register_console v try_enable_new_console v s3c24xx_serial_console_setup But because the serial driver is built-in, and s3c24xx_serial_console_setup() is marked with __init keyword, that symbol will discarded and long gone by that time already, causing failed paging request. That happens during the next config combination: EXYNOS_USI=m SERIAL_SAMSUNG=y SERIAL_SAMSUNG_CONSOLE=y That config should be completely possible, so rather than limiting SERIAL_SAMSUNG choice to "m" only when USI=m, remove __init keyword for all affected functions. Signed-off-by: Sam Protsenko <semen.protsenko@linaro.org> --- Changes in v3: - (none) Changes in v2: - This patch is added in v2 drivers/tty/serial/samsung_tty.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)