diff mbox series

[RESEND,v3,4/9] pinctrl: mediatek: moore: check if pin_desc is valid before use

Message ID 20210914085137.31761-5-sam.shih@mediatek.com
State New
Headers show
Series [v3,1/9] dt-bindings: clock: mediatek: document clk bindings for mediatek mt7986 SoC | expand

Commit Message

Sam Shih Sept. 14, 2021, 8:51 a.m. UTC 
Certain SoC are missing the middle part gpios in consecutive pins,
it's better to check if mtk_pin_desc is a valid pin for the extensibility

Signed-off-by: Sam Shih <sam.shih@mediatek.com>
Acked-by: Sean Wang <sean.wang@mediatek.com>

---
v3: added an Acked-by tag.
v2: applied the comment suggested by reviewers:
    - for the pins not ballout, we can fill .name in struct mtk_pin_desc
      as NULL and return -ENOTSUPP in gpio/pinconf ops.
---
 drivers/pinctrl/mediatek/pinctrl-moore.c | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

Comments

Linus Walleij Sept. 16, 2021, 10:07 a.m. UTC | #1 
On Tue, Sep 14, 2021 at 10:52 AM Sam Shih <sam.shih@mediatek.com> wrote:

> Certain SoC are missing the middle part gpios in consecutive pins,

> it's better to check if mtk_pin_desc is a valid pin for the extensibility

>

> Signed-off-by: Sam Shih <sam.shih@mediatek.com>

> Acked-by: Sean Wang <sean.wang@mediatek.com>


This patch applied for v5.16 so we get some stuff merged.

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/drivers/pinctrl/mediatek/pinctrl-moore.c b/drivers/pinctrl/mediatek/pinctrl-moore.c
index 3a4a23c40a71..ad3b67163973 100644
--- a/drivers/pinctrl/mediatek/pinctrl-moore.c
+++ b/drivers/pinctrl/mediatek/pinctrl-moore.c
@@ -60,6 +60,8 @@  static int mtk_pinmux_set_mux(struct pinctrl_dev *pctldev,
 		int pin = grp->pins[i];
 
 		desc = (const struct mtk_pin_desc *)&hw->soc->pins[pin];
+		if (!desc->name)
+			return -ENOTSUPP;
 
 		mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_MODE,
 				 pin_modes[i]);
@@ -76,6 +78,8 @@  static int mtk_pinmux_gpio_request_enable(struct pinctrl_dev *pctldev,
 	const struct mtk_pin_desc *desc;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[pin];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	return mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_MODE,
 				hw->soc->gpio_m);
@@ -89,6 +93,8 @@  static int mtk_pinmux_gpio_set_direction(struct pinctrl_dev *pctldev,
 	const struct mtk_pin_desc *desc;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[pin];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	/* hardware would take 0 as input direction */
 	return mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DIR, !input);
@@ -103,6 +109,8 @@  static int mtk_pinconf_get(struct pinctrl_dev *pctldev,
 	const struct mtk_pin_desc *desc;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[pin];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	switch (param) {
 	case PIN_CONFIG_BIAS_DISABLE:
@@ -218,6 +226,8 @@  static int mtk_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin,
 	int cfg, err = 0;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[pin];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	for (cfg = 0; cfg < num_configs; cfg++) {
 		param = pinconf_to_config_param(configs[cfg]);
@@ -435,6 +445,8 @@  static int mtk_gpio_get(struct gpio_chip *chip, unsigned int gpio)
 	int value, err;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[gpio];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	err = mtk_hw_get_value(hw, desc, PINCTRL_PIN_REG_DI, &value);
 	if (err)
@@ -449,6 +461,10 @@  static void mtk_gpio_set(struct gpio_chip *chip, unsigned int gpio, int value)
 	const struct mtk_pin_desc *desc;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[gpio];
+	if (!desc->name) {
+		dev_err(hw->dev, "Failed to set gpio %d\n", gpio);
+		return;
+	}
 
 	mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DO, !!value);
 }
@@ -490,6 +506,8 @@  static int mtk_gpio_set_config(struct gpio_chip *chip, unsigned int offset,
 	u32 debounce;
 
 	desc = (const struct mtk_pin_desc *)&hw->soc->pins[offset];
+	if (!desc->name)
+		return -ENOTSUPP;
 
 	if (!hw->eint ||
 	    pinconf_to_config_param(config) != PIN_CONFIG_INPUT_DEBOUNCE ||