@@ -23,12 +23,25 @@ Optional properties :
- i2c-disable-after-xfer : If set, driver will disable I2C module
after msg xfer and enable it again before xfer.
+ (Applicable to PXA910 family):
+
+ - i2c-sclk-low-time-ns : SCLK low time (tlow), for standard/fast/high
+ speed mode.
+ This property is used along with mode selection. Driver uses this property
+ to set low/high time for standard and fast speed mode, as HW counter
+ bit-field is same for both.
+ - i2c-sclk-high-time-ns : SCLK high time (thigh), Used in case of high speed
+ mode only.
+
Examples:
twsi1: i2c@d4011000 {
compatible = "mrvl,mmp-twsi";
reg = <0xd4011000 0x1000>;
interrupts = <7>;
mrvl,i2c-fast-mode;
+
+ i2c-sclk-low-time-ns = <988>;
+ i2c-sclk-high-time-ns = <988>;
};
twsi2: i2c@d4025000 {
With addition of PXA910 family of devices, the TWSI module supports new feature which allows us to adjust SCLK. i2c-pxa driver takes input configuration in nsec and converts it to respective bit-fields, - i2c-sclk-low-time-ns : SCLK low time (tlow) This property is used along with mode selection. - i2c-sclk-high-time-ns : SCLK high time (thigh) - i2c-start-hold-time-ns : Used in case of high speed mode for start bit hold/setup wait counter. - i2c-stop-hold-time-ns : Used in case of high speed mode for stop bit hold/setup wait counter. - i2c-sda-hold-time-ns : Used to calculate hold/setup wait counter for standard and fast mode. Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@linaro.org> --- Documentation/devicetree/bindings/i2c/i2c-pxa.txt | 13 +++++++++++++ 1 file changed, 13 insertions(+)