@@ -328,6 +328,13 @@ static void iwl_fwrt_dump_tcm_error_log(struct iwl_fw_runtime *fwrt)
for (i = 0; i < ARRAY_SIZE(table.sw_status); i++)
IWL_ERR(fwrt, "0x%08X | tcm SW status[%d]\n",
table.sw_status[i], i);
+
+ if (trans->trans_cfg->device_family >= IWL_DEVICE_FAMILY_BZ) {
+ u32 scratch = iwl_read32(trans, CSR_FUNC_SCRATCH);
+
+ IWL_ERR(fwrt, "Function Scratch status:\n");
+ IWL_ERR(fwrt, "0x%08X | Func Scratch\n", scratch);
+ }
}
static void iwl_fwrt_dump_iml_error_log(struct iwl_fw_runtime *fwrt)
@@ -34,6 +34,7 @@
#define CSR_GPIO_IN (CSR_BASE+0x018) /* read external chip pins */
#define CSR_RESET (CSR_BASE+0x020) /* busmaster enable, NMI, etc*/
#define CSR_GP_CNTRL (CSR_BASE+0x024)
+#define CSR_FUNC_SCRATCH (CSR_BASE+0x02c) /* Scratch register - used for FW dbg */
/* 2nd byte of CSR_INT_COALESCING, not accessible via iwl_write32()! */
#define CSR_INT_PERIODIC_REG (CSR_BASE+0x005)
@@ -135,6 +136,12 @@
#define CSR_DBG_HPET_MEM_REG (CSR_BASE+0x240)
#define CSR_DBG_LINK_PWR_MGMT_REG (CSR_BASE+0x250)
+/*
+ * Scratch register initial configuration - this is set on init, and read
+ * during a error FW error.
+ */
+#define CSR_FUNC_SCRATCH_INIT_VALUE (0x01010101)
+
/* Bits for CSR_HW_IF_CONFIG_REG */
#define CSR_HW_IF_CONFIG_REG_MSK_MAC_DASH (0x00000003)
#define CSR_HW_IF_CONFIG_REG_MSK_MAC_STEP (0x0000000C)
@@ -466,13 +466,15 @@ int iwl_trans_pcie_gen2_start_fw(struct iwl_trans *trans,
iwl_pcie_set_ltr(trans);
- if (trans->trans_cfg->device_family >= IWL_DEVICE_FAMILY_BZ)
+ if (trans->trans_cfg->device_family >= IWL_DEVICE_FAMILY_BZ) {
+ iwl_write32(trans, CSR_FUNC_SCRATCH, CSR_FUNC_SCRATCH_INIT_VALUE);
iwl_set_bit(trans, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_ROM_START);
- else if (trans->trans_cfg->device_family >= IWL_DEVICE_FAMILY_AX210)
+ } else if (trans->trans_cfg->device_family >= IWL_DEVICE_FAMILY_AX210) {
iwl_write_umac_prph(trans, UREG_CPU_INIT_RUN, 1);
- else
+ } else {
iwl_write_prph(trans, UREG_CPU_INIT_RUN, 1);
+ }
/* re-check RF-Kill state since we may have missed the interrupt */
hw_rfkill = iwl_pcie_check_hw_rf_kill(trans);