@@ -206,11 +206,6 @@ struct sec_ctx {
struct device *dev;
};
-enum sec_endian {
- SEC_LE = 0,
- SEC_32BE,
- SEC_64BE
-};
enum sec_debug_file_index {
SEC_CLEAR_ENABLE,
@@ -318,31 +318,20 @@ static const struct pci_device_id sec_dev_ids[] = {
};
MODULE_DEVICE_TABLE(pci, sec_dev_ids);
-static u8 sec_get_endian(struct hisi_qm *qm)
+static void sec_set_endian(struct hisi_qm *qm)
{
u32 reg;
- /*
- * As for VF, it is a wrong way to get endian setting by
- * reading a register of the engine
- */
- if (qm->pdev->is_virtfn) {
- dev_err_ratelimited(&qm->pdev->dev,
- "cannot access a register in VF!\n");
- return SEC_LE;
- }
reg = readl_relaxed(qm->io_base + SEC_CONTROL_REG);
- /* BD little endian mode */
- if (!(reg & BIT(0)))
- return SEC_LE;
+ reg &= ~(BIT(1) | BIT(0));
+ if (!IS_ENABLED(CONFIG_64BIT))
+ reg |= BIT(1);
- /* BD 32-bits big endian mode */
- else if (!(reg & BIT(1)))
- return SEC_32BE;
- /* BD 64-bits big endian mode */
- else
- return SEC_64BE;
+ if (!IS_ENABLED(CONFIG_CPU_LITTLE_ENDIAN))
+ reg |= BIT(0);
+
+ writel_relaxed(reg, qm->io_base + SEC_CONTROL_REG);
}
static void sec_open_sva_prefetch(struct hisi_qm *qm)
@@ -463,9 +452,7 @@ static int sec_engine_init(struct hisi_qm *qm)
qm->io_base + SEC_BD_ERR_CHK_EN_REG3);
/* config endian */
- reg = readl_relaxed(qm->io_base + SEC_CONTROL_REG);
- reg |= sec_get_endian(qm);
- writel_relaxed(reg, qm->io_base + SEC_CONTROL_REG);
+ sec_set_endian(qm);
sec_enable_clock_gate(qm);
When the endian configuration of the hardware is abnormal, it will cause the SEC engine is faulty that reports empty message. And it will affect the normal function of the hardware. Currently the soft configuration method can't restore the faulty device. The endian needs to be configured according to the system properties. So fix it. Signed-off-by: Kai Ye <yekai13@huawei.com> --- drivers/crypto/hisilicon/sec2/sec.h | 5 ----- drivers/crypto/hisilicon/sec2/sec_main.c | 31 +++++++++---------------------- 2 files changed, 9 insertions(+), 27 deletions(-)