@@ -51,6 +51,7 @@
/**
* struct bcm_device_data - device specific data
* @no_early_set_baudrate: Disallow set baudrate before driver setup()
+ * @drive_rts_on_open: drive RTS signal on ->open() when platform requires it
*/
struct bcm_device_data {
bool no_early_set_baudrate;
@@ -77,6 +78,8 @@ struct bcm_device_data {
* @btlp: Apple ACPI method to toggle BT_WAKE pin ("Bluetooth Low Power")
* @btpu: Apple ACPI method to drive BT_REG_ON pin high ("Bluetooth Power Up")
* @btpd: Apple ACPI method to drive BT_REG_ON pin low ("Bluetooth Power Down")
+ * @gpio_count: internal counter for GPIO resources associated with ACPI device
+ * @gpio_int_idx: index in _CRS for GpioInt() resource
* @txco_clk: external reference frequency clock used by Bluetooth device
* @lpo_clk: external LPO clock used by Bluetooth device
* @supplies: VBAT and VDDIO supplies used by Bluetooth device
@@ -88,10 +91,13 @@ struct bcm_device_data {
* set to 0 if @init_speed is already the preferred baudrate
* @irq: interrupt triggered by HOST_WAKE_BT pin
* @irq_active_low: whether @irq is active low
+ * @irq_acquired: flag to show if IRQ handler has been assigned
* @hu: pointer to HCI UART controller struct,
* used to disable flow control during runtime suspend and system sleep
* @is_suspended: whether flow control is currently disabled
* @no_early_set_baudrate: don't set_baudrate before setup()
+ * @drive_rts_on_open: drive RTS signal on ->open() when platform requires it
+ * @pcm_int_params: keep the initial PCM configuration
*/
struct bcm_device {
/* Must be the first member, hci_serdev.c expects this. */
Kernel doc validator complains about few missed parameter descriptions. Fill the gap by describing them. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/bluetooth/hci_bcm.c | 6 ++++++ 1 file changed, 6 insertions(+)