diff mbox

[1/2] mmc: mmci: Prepare for SDIO before setting up DMA job

Message ID 1319464243-16638-2-git-send-email-ulf.hansson@stericsson.com
State Superseded
Headers show

Commit Message

Ulf Hansson Oct. 24, 2011, 1:50 p.m. UTC 
Move the SDIO preparation to be done before the DMA job is setup.
This makes it possible to do DMA for SDIO transfers as well as the
earlier supported pio mode.

Signed-off-by: Ulf Hansson <ulf.hansson@stericsson.com>
Signed-off-by: Stefan Nilsson XK <stefan.xk.nilsson@stericsson.com>
---
 drivers/mmc/host/mmci.c |   10 +++++-----
 1 files changed, 5 insertions(+), 5 deletions(-)
diff mbox

Patch

diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 50b5f99..1b73177 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -604,6 +604,11 @@  static void mmci_start_data(struct mmci_host *host, struct mmc_data *data)
 	if (data->flags & MMC_DATA_READ)
 		datactrl |= MCI_DPSM_DIRECTION;
 
+	/* The ST Micro variants has a special bit to enable SDIO */
+	if (variant->sdio && host->mmc->card)
+		if (mmc_card_sdio(host->mmc->card))
+			datactrl |= MCI_ST_DPSM_SDIOEN;
+
 	/*
 	 * Attempt to use DMA operation mode, if this
 	 * should fail, fall back to PIO mode
@@ -632,11 +637,6 @@  static void mmci_start_data(struct mmci_host *host, struct mmc_data *data)
 		irqmask = MCI_TXFIFOHALFEMPTYMASK;
 	}
 
-	/* The ST Micro variants has a special bit to enable SDIO */
-	if (variant->sdio && host->mmc->card)
-		if (mmc_card_sdio(host->mmc->card))
-			datactrl |= MCI_ST_DPSM_SDIOEN;
-
 	writel(datactrl, base + MMCIDATACTRL);
 	writel(readl(base + MMCIMASK0) & ~MCI_DATAENDMASK, base + MMCIMASK0);
 	mmci_set_mask1(host, irqmask);