@@ -186,6 +186,7 @@ mcbsp3: mcbsp@0 {
};
target-module@28000 { /* 0x40128000, ap 8 08.0 */
+ /* 0x4012a000, ap 10 0a.0 */
compatible = "ti,sysc-mcasp", "ti,sysc";
reg = <0x28000 0x4>,
<0x28004 0x4>;
@@ -199,23 +200,25 @@ target-module@28000 { /* 0x40128000, ap 8 08.0 */
#address-cells = <1>;
#size-cells = <1>;
ranges = <0x0 0x28000 0x1000>,
- <0x49028000 0x49028000 0x1000>;
-
- /*
- * Child device unsupported by davinci-mcasp. At least
- * RX path is disabled for omap4, and only DIT mode
- * works with no I2S. See also old Android kernel
- * omap-mcasp driver for more information.
- */
- };
-
- target-module@2a000 { /* 0x4012a000, ap 10 0a.0 */
- compatible = "ti,sysc";
- status = "disabled";
- #address-cells = <1>;
- #size-cells = <1>;
- ranges = <0x0 0x2a000 0x1000>,
+ <0x49028000 0x49028000 0x1000>,
+ <0x2000 0x2a000 0x1000>,
<0x4902a000 0x4902a000 0x1000>;
+
+ mcasp0: mcasp@0 {
+ compatible = "ti,omap4-mcasp-audio";
+ reg = <0x0 0x2000>,
+ <0x4902a000 0x1000>; /* L3 data port */
+ reg-names = "mpu","dat";
+ interrupts = <GIC_SPI 109 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "tx";
+ dmas = <&sdma 8>;
+ dma-names = "tx";
+ clocks = <&abe_clkctrl OMAP4_MCASP_CLKCTRL 0>;
+ clock-names = "fck";
+ op-mode = <1>; /* MCASP_DIT_MODE */
+ serial-dir = < 1 >; /* 1 TX serializers */
+ status = "disabled";
+ };
};
target-module@2e000 { /* 0x4012e000, ap 12 0c.0 */
OMAP4 has a single McASP instance with single serializer and locked for DIT mode. To be able to enable the support the following fixes needed: - Add the DAT port ranges to the target module's ranges We can already fill in the op-mode and serial-dir for McASP as it only supports this configuration, but keep the module disabled as there is no known device available where it is used. Signed-off-by: Peter Ujfalusi <peter.ujfalusi@gmail.com> --- arch/arm/boot/dts/omap4-l4-abe.dtsi | 35 ++++++++++++++++------------- 1 file changed, 19 insertions(+), 16 deletions(-)