@@ -352,8 +352,6 @@ static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
}
mr = spi_readl(as, MR);
- if (spi->cs_gpiod)
- gpiod_set_value(spi->cs_gpiod, 1);
} else {
u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0;
int i;
@@ -369,8 +367,6 @@ static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
mr = spi_readl(as, MR);
mr = SPI_BFINS(PCS, ~(1 << chip_select), mr);
- if (spi->cs_gpiod)
- gpiod_set_value(spi->cs_gpiod, 1);
spi_writel(as, MR, mr);
}
@@ -400,8 +396,6 @@ static void cs_deactivate(struct atmel_spi *as, struct spi_device *spi)
if (!spi->cs_gpiod)
spi_writel(as, CR, SPI_BIT(LASTXFER));
- else
- gpiod_set_value(spi->cs_gpiod, 0);
}
static void atmel_spi_lock(struct atmel_spi *as) __acquires(&as->lock)
@@ -1271,9 +1265,9 @@ static void atmel_spi_set_cs(struct spi_device *spi, bool enable)
* since we already have routines for activate/deactivate translate
* high/low to active/inactive
*/
- enable = (!!(spi->mode & SPI_CS_HIGH) == enable);
- if (enable) {
+ if ((enable && (spi->mode & SPI_CS_HIGH))
+ || (!enable && !(spi->mode & SPI_CS_HIGH))) {
cs_activate(as, spi);
} else {
cs_deactivate(as, spi);
@@ -1483,7 +1477,8 @@ static int atmel_spi_probe(struct platform_device *pdev)
master->bus_num = pdev->id;
master->num_chipselect = 4;
master->setup = atmel_spi_setup;
- master->flags = (SPI_MASTER_MUST_RX | SPI_MASTER_MUST_TX);
+ master->flags = (SPI_MASTER_MUST_RX | SPI_MASTER_MUST_TX |
+ SPI_MASTER_GPIO_SS);
master->transfer_one = atmel_spi_one_transfer;
master->set_cs = atmel_spi_set_cs;
master->cleanup = atmel_spi_cleanup;
Commit 5fa5e6dec762 ("spi: atmel: Switch to transfer_one transfer method") switched to using transfer_one and set_cs. However, the driver expects to call cs_activate even with a gpio controlled chip select. If cs_activate isn't called the settings programmed with the call to spi_setup won't get programmed into the hardware. This patch makes sure the cs_activate call is made even with a gpio controlled chip select. Fixes: 5fa5e6dec762 ("spi: atmel: Switch to transfer_one transfer method") Signed-off-by: Dan Sneddon <dan.sneddon@microchip.com> --- drivers/spi/spi-atmel.c | 13 ++++--------- 1 file changed, 4 insertions(+), 9 deletions(-)