Message ID | 20210611014755.124483-1-breno.lima@nxp.com |
---|---|
State | Superseded |
Headers | show |
Series | mx8mm: usb: chipidea: Fix Battery Charger 1.2 CDP detection | expand |
> -----Original Message----- > From: Breno Matheus Lima <breno.lima@nxp.com> > Sent: Friday, June 11, 2021 9:48 AM > To: peter.chen@kernel.org > Cc: gregkh@linuxfoundation.org; shawnguo@kernel.org; > s.hauer@pengutronix.de; kernel@pengutronix.de; festevam@gmail.com; > dl-linux-imx <linux-imx@nxp.com>; linux-usb@vger.kernel.org; > linux-arm-kernel@lists.infradead.org; linux-kernel@vger.kernel.org; > brenomatheus@gmail.com; Jun Li <jun.li@nxp.com>; Breno Matheus Lima > <breno.lima@nxp.com> > Subject: [PATCH] mx8mm: usb: chipidea: Fix Battery Charger 1.2 CDP detection > > i.MX8MM cannot detect certain CDP USB HUBs. usbmisc_imx.c driver is not > following CDP timing requirements defined by USB BC 1.2 specification and > section 3.2.4 Detection Timing CDP. > > During Primary Detection the i.MX device should turn on VDP_SRC and IDM_SINK > for a minimum of 40ms (TVDPSRC_ON). After a time of TVDPSRC_ON, the PD is > allowed to check the status of the D- line. Current implementation is waiting > between 1ms and 2ms, and certain BC 1.2 complaint USB HUBs cannot be detected. > Increase delay to 40ms allowing enough time for primary detection. > > During secondary detection the PD is required to disable VDP_SRC and IDM_SNK, > and enable VDM_SRC and IDP_SINK for at least 40ms (TVDMSRC_ON). > > Current implementation is not disabling VDP_SRC and IDM_SNK, introduce > disable sequence in imx7d_charger_secondary_detection() function. > > VDM_SRC and IDP_SINK should be enabled for at least 40ms (TVDMSRC_ON). > Increase delay allowing enough time for detection. > Fixes: 746f316b753a ("usb: chipidea: introduce imx7d USB charger detection") > Signed-off-by: Breno Lima <breno.lima@nxp.com> > Signed-off-by: Jun Li <jun.li@nxp.com> > --- > drivers/usb/chipidea/usbmisc_imx.c | 16 ++++++++++++++-- > 1 file changed, 14 insertions(+), 2 deletions(-) > > diff --git a/drivers/usb/chipidea/usbmisc_imx.c > b/drivers/usb/chipidea/usbmisc_imx.c > index 4545b23bda3f..bac0f5458cab 100644 > --- a/drivers/usb/chipidea/usbmisc_imx.c > +++ b/drivers/usb/chipidea/usbmisc_imx.c > @@ -686,6 +686,16 @@ static int imx7d_charger_secondary_detection(struct > imx_usbmisc_data *data) > int val; > unsigned long flags; > > + /* Clear VDATSRCENB0 to disable VDP_SRC and IDM_SNK required by BC 1.2 > spec */ > + spin_lock_irqsave(&usbmisc->lock, flags); > + val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2); > + val &= ~MX7D_USB_OTG_PHY_CFG2_CHRG_VDATSRCENB0; > + writel(val, usbmisc->base + MX7D_USB_OTG_PHY_CFG2); > + spin_unlock_irqrestore(&usbmisc->lock, flags); > + > + /* TVDMSRC_DIS */ > + msleep(20); > + > /* VDM_SRC is connected to D- and IDP_SINK is connected to D+ */ > spin_lock_irqsave(&usbmisc->lock, flags); > val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2); @@ -695,7 +705,8 > @@ static int imx7d_charger_secondary_detection(struct imx_usbmisc_data > *data) > usbmisc->base + MX7D_USB_OTG_PHY_CFG2); > spin_unlock_irqrestore(&usbmisc->lock, flags); > > - usleep_range(1000, 2000); > + /* TVDMSRC_ON */ > + msleep(40); > > /* > * Per BC 1.2, check voltage of D+: > @@ -798,7 +809,8 @@ static int imx7d_charger_primary_detection(struct > imx_usbmisc_data *data) > usbmisc->base + MX7D_USB_OTG_PHY_CFG2); > spin_unlock_irqrestore(&usbmisc->lock, flags); > > - usleep_range(1000, 2000); > + /* TVDPSRC_ON */ > + msleep(40); > > /* Check if D- is less than VDAT_REF to determine an SDP per BC 1.2 */ > val = readl(usbmisc->base + MX7D_USB_OTG_PHY_STATUS); > -- > 2.25.1
Hi Jun, Em sex., 11 de jun. de 2021 às 02:24, Jun Li <jun.li@nxp.com> escreveu: > > > > -----Original Message----- > > From: Breno Matheus Lima <breno.lima@nxp.com> > > Sent: Friday, June 11, 2021 9:48 AM > > To: peter.chen@kernel.org > > Cc: gregkh@linuxfoundation.org; shawnguo@kernel.org; > > s.hauer@pengutronix.de; kernel@pengutronix.de; festevam@gmail.com; > > dl-linux-imx <linux-imx@nxp.com>; linux-usb@vger.kernel.org; > > linux-arm-kernel@lists.infradead.org; linux-kernel@vger.kernel.org; > > brenomatheus@gmail.com; Jun Li <jun.li@nxp.com>; Breno Matheus Lima > > <breno.lima@nxp.com> > > Subject: [PATCH] mx8mm: usb: chipidea: Fix Battery Charger 1.2 CDP detection > > > > i.MX8MM cannot detect certain CDP USB HUBs. usbmisc_imx.c driver is not > > following CDP timing requirements defined by USB BC 1.2 specification and > > section 3.2.4 Detection Timing CDP. > > > > During Primary Detection the i.MX device should turn on VDP_SRC and IDM_SINK > > for a minimum of 40ms (TVDPSRC_ON). After a time of TVDPSRC_ON, the PD is > > allowed to check the status of the D- line. Current implementation is waiting > > between 1ms and 2ms, and certain BC 1.2 complaint USB HUBs cannot be detected. > > Increase delay to 40ms allowing enough time for primary detection. > > > > During secondary detection the PD is required to disable VDP_SRC and IDM_SNK, > > and enable VDM_SRC and IDP_SINK for at least 40ms (TVDMSRC_ON). > > > > Current implementation is not disabling VDP_SRC and IDM_SNK, introduce > > disable sequence in imx7d_charger_secondary_detection() function. > > > > VDM_SRC and IDP_SINK should be enabled for at least 40ms (TVDMSRC_ON). > > Increase delay allowing enough time for detection. > > > > Fixes: 746f316b753a ("usb: chipidea: introduce imx7d USB charger detection") > Thanks for pointing this out, I have just sent another version. Best regards, Breno Lima
diff --git a/drivers/usb/chipidea/usbmisc_imx.c b/drivers/usb/chipidea/usbmisc_imx.c index 4545b23bda3f..bac0f5458cab 100644 --- a/drivers/usb/chipidea/usbmisc_imx.c +++ b/drivers/usb/chipidea/usbmisc_imx.c @@ -686,6 +686,16 @@ static int imx7d_charger_secondary_detection(struct imx_usbmisc_data *data) int val; unsigned long flags; + /* Clear VDATSRCENB0 to disable VDP_SRC and IDM_SNK required by BC 1.2 spec */ + spin_lock_irqsave(&usbmisc->lock, flags); + val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2); + val &= ~MX7D_USB_OTG_PHY_CFG2_CHRG_VDATSRCENB0; + writel(val, usbmisc->base + MX7D_USB_OTG_PHY_CFG2); + spin_unlock_irqrestore(&usbmisc->lock, flags); + + /* TVDMSRC_DIS */ + msleep(20); + /* VDM_SRC is connected to D- and IDP_SINK is connected to D+ */ spin_lock_irqsave(&usbmisc->lock, flags); val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2); @@ -695,7 +705,8 @@ static int imx7d_charger_secondary_detection(struct imx_usbmisc_data *data) usbmisc->base + MX7D_USB_OTG_PHY_CFG2); spin_unlock_irqrestore(&usbmisc->lock, flags); - usleep_range(1000, 2000); + /* TVDMSRC_ON */ + msleep(40); /* * Per BC 1.2, check voltage of D+: @@ -798,7 +809,8 @@ static int imx7d_charger_primary_detection(struct imx_usbmisc_data *data) usbmisc->base + MX7D_USB_OTG_PHY_CFG2); spin_unlock_irqrestore(&usbmisc->lock, flags); - usleep_range(1000, 2000); + /* TVDPSRC_ON */ + msleep(40); /* Check if D- is less than VDAT_REF to determine an SDP per BC 1.2 */ val = readl(usbmisc->base + MX7D_USB_OTG_PHY_STATUS);