@@ -8,6 +8,7 @@
#include "pmi8994.dtsi"
#include <dt-bindings/input/input.h>
#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/leds/common.h>
#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
#include <dt-bindings/sound/qcom,q6afe.h>
#include <dt-bindings/sound/qcom,q6asm.h>
@@ -682,6 +683,54 @@ pinconf {
};
};
+&pmi8994_lpg {
+ qcom,power-source = <1>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&pmi8994_mpp2_userled4>;
+
+ qcom,dtest = <0 0
+ 0 0
+ 0 0
+ 4 1>;
+
+ status = "okay";
+
+ led@1 {
+ reg = <1>;
+ label = "green:user1";
+
+ linux,default-trigger = "heartbeat";
+ default-state = "on";
+ };
+
+ led@2 {
+ reg = <2>;
+ label = "green:user0";
+ default-state = "on";
+ };
+
+ led@3 {
+ reg = <3>;
+ label = "green:user2";
+ };
+
+ led@4 {
+ reg = <4>;
+ label = "green:user3";
+ };
+};
+
+&pmi8994_mpps {
+ pmi8994_mpp2_userled4: mpp2-userled4-state {
+ pins = "mpp2";
+ function = "sink";
+
+ output-low;
+ qcom,dtest = <4>;
+ };
+};
+
&pmi8994_spmi_regulators {
vdd_gfx: s2@1700 {
reg = <0x1700 0x100>;
The db820c has 4 "user LEDs", all connected to the PMI8994. The first three are connected to the three current sinks provided by the TRILED and the fourth is connected to MPP2. By utilizing the DTEST bus the MPP is fed the control signal from the fourth LPG block, providing a consistent interface to the user. Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> --- Changes since v6: - Changed sort order arch/arm64/boot/dts/qcom/apq8096-db820c.dtsi | 49 ++++++++++++++++++++ 1 file changed, 49 insertions(+) -- 2.29.2