@@ -1160,11 +1160,14 @@ static int zynqmp_qspi_probe(struct platform_device *pdev)
pm_runtime_set_autosuspend_delay(&pdev->dev, SPI_AUTOSUSPEND_TIMEOUT);
pm_runtime_set_active(&pdev->dev);
pm_runtime_enable(&pdev->dev);
+
+ ret = pm_runtime_get_sync(&pdev->dev);
+ if (ret < 0)
+ goto clk_dis_all;
+
/* QSPI controller initializations */
zynqmp_qspi_init_hw(xqspi);
- pm_runtime_mark_last_busy(&pdev->dev);
- pm_runtime_put_autosuspend(&pdev->dev);
xqspi->irq = platform_get_irq(pdev, 0);
if (xqspi->irq <= 0) {
ret = -ENXIO;
@@ -1187,6 +1190,7 @@ static int zynqmp_qspi_probe(struct platform_device *pdev)
ctlr->mode_bits = SPI_CPOL | SPI_CPHA | SPI_RX_DUAL | SPI_RX_QUAD |
SPI_TX_DUAL | SPI_TX_QUAD;
ctlr->dev.of_node = np;
+ ctlr->auto_runtime_pm = true;
ret = devm_spi_register_controller(&pdev->dev, ctlr);
if (ret) {
@@ -1194,9 +1198,13 @@ static int zynqmp_qspi_probe(struct platform_device *pdev)
goto clk_dis_all;
}
+ pm_runtime_mark_last_busy(&pdev->dev);
+ pm_runtime_put_autosuspend(&pdev->dev);
+
return 0;
clk_dis_all:
+ pm_runtime_put_sync(&pdev->dev);
pm_runtime_set_suspended(&pdev->dev);
pm_runtime_disable(&pdev->dev);
clk_disable_unprepare(xqspi->refclk);
There is a PM usage counter decrement after zynqmp_qspi_init_hw() without any refcount increment, which leads to refcount leak.Add a refcount increment to balance the refcount. Also set auto_runtime_pm to resume suspended spi controller. Fixes: 9e3a000362aec ("spi: zynqmp: Add pm runtime support") Signed-off-by: Dinghao Liu <dinghao.liu@zju.edu.cn> --- Changelog: v2: - Add a refcount increment to fix refcout leak instead of the refcount decrement on error. Set ctlr->auto_runtime_pm = true. v3: - Add fix tag. Add a return value check against pm_runtime_get_sync(). Move pm_runtime_{mark_last_busy & put_autosuspend} to the end of current function. --- drivers/spi/spi-zynqmp-gqspi.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-)