@@ -586,10 +586,8 @@ static int dp_connect_pending_timeout(struct dp_display_private *dp, u32 data)
mutex_lock(&dp->event_mutex);
state = dp->hpd_state;
- if (state == ST_CONNECT_PENDING) {
- dp_display_enable(dp, 0);
+ if (state == ST_CONNECT_PENDING)
dp->hpd_state = ST_CONNECTED;
- }
mutex_unlock(&dp->event_mutex);
@@ -669,10 +667,8 @@ static int dp_disconnect_pending_timeout(struct dp_display_private *dp, u32 data
mutex_lock(&dp->event_mutex);
state = dp->hpd_state;
- if (state == ST_DISCONNECT_PENDING) {
- dp_display_disable(dp, 0);
+ if (state == ST_DISCONNECT_PENDING)
dp->hpd_state = ST_DISCONNECTED;
- }
mutex_unlock(&dp->event_mutex);
@@ -1272,7 +1268,12 @@ static int dp_pm_resume(struct device *dev)
status = dp_catalog_link_is_connected(dp->catalog);
- if (status)
+ /*
+ * can not declared display is connected unless
+ * HDMI cable is plugged in and sink_count of
+ * dongle become 1
+ */
+ if (status && dp->link->sink_count)
dp->dp_display.is_connected = true;
else
dp->dp_display.is_connected = false;
Link status is different from display connected status in the case of something like an Apple dongle where the type-c plug can be connected, and therefore the link is connected, but no sink is connected until an HDMI cable is plugged into the dongle. The sink_count of DPCD of dongle will increase to 1 once an HDMI cable is plugged into the dongle so that display connected status will become true. This checking also apply at pm_resume. Fixes: 94e58e2d06e3 ("drm/msm/dp: reset dp controller only at boot up and pm_resume") Reported-by: Stephen Boyd <swboyd@chromium.org> Signed-off-by: Kuogee Hsieh <khsieh@codeaurora.org> --- drivers/gpu/drm/msm/dp/dp_display.c | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-)