diff mbox

[1/4] pwm: kona: Remove setting default smooth type and polarity for all channels

Message ID 1415989800-7515-2-git-send-email-sbranden@broadcom.com
State New
Headers show

Commit Message

Scott Branden Nov. 14, 2014, 6:29 p.m. UTC 
From: Arun Ramamurthy <arunrama@broadcom.com>

The probe routine unnecessarily sets the smooth type and polarity for
all channels. This causes the channel for the speaker to click at the same
time the backlight turns on. The smooth type and polarity should be set individually
for each channel as required and no defaults need to be set.

Signed-off-by: Arun Ramamurthy <arunrama@broadcom.com>
Reviewed-by: Ray Jui <rjui@broadcom.com>
Signed-off-by: Scott Branden <sbranden@broadcom.com>
---
 drivers/pwm/pwm-bcm-kona.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)
diff mbox

Patch

diff --git a/drivers/pwm/pwm-bcm-kona.c b/drivers/pwm/pwm-bcm-kona.c
index 02bc048..29eef9e 100644
--- a/drivers/pwm/pwm-bcm-kona.c
+++ b/drivers/pwm/pwm-bcm-kona.c
@@ -266,12 +266,9 @@  static int kona_pwmc_probe(struct platform_device *pdev)
 		return ret;
 	}
 
-	/* Set smooth mode, push/pull, and normal polarity for all channels */
-	for (chan = 0; chan < kp->chip.npwm; chan++) {
-		value |= (1 << PWM_CONTROL_SMOOTH_SHIFT(chan));
+	/* Set push/pull for all channels */
+	for (chan = 0; chan < kp->chip.npwm; chan++)
 		value |= (1 << PWM_CONTROL_TYPE_SHIFT(chan));
-		value |= (1 << PWM_CONTROL_POLARITY_SHIFT(chan));
-	}
 
 	writel(value, kp->base + PWM_CONTROL_OFFSET);