@@ -284,7 +284,7 @@ enum iwl_legacy_cmds {
/* Phy */
/**
- * @PHY_CONFIGURATION_CMD: &struct iwl_phy_cfg_cmd
+ * @PHY_CONFIGURATION_CMD: &struct iwl_phy_cfg_cmd_v1 or &struct iwl_phy_cfg_cmd_v3
*/
PHY_CONFIGURATION_CMD = 0x6a,
@@ -12,7 +12,12 @@
enum iwl_location_subcmd_ids {
/**
* @TOF_RANGE_REQ_CMD: TOF ranging request,
- * uses &struct iwl_tof_range_req_cmd
+ * uses one of &struct iwl_tof_range_req_cmd_v5,
+ * &struct iwl_tof_range_req_cmd_v7,
+ * &struct iwl_tof_range_req_cmd_v8,
+ * &struct iwl_tof_range_req_cmd_v9,
+ * &struct iwl_tof_range_req_cmd_v11,
+ * &struct iwl_tof_range_req_cmd_v7
*/
TOF_RANGE_REQ_CMD = 0x0,
/**
@@ -20,6 +20,7 @@
* @TX_CMD_FLG_VHT_NDPA: mark frame is NDPA for VHT beamformer sequence
* @TX_CMD_FLG_HT_NDPA: mark frame is NDPA for HT beamformer sequence
* @TX_CMD_FLG_CSI_FDBK2HOST: mark to send feedback to host (only if good CRC)
+ * @TX_CMD_FLG_BT_PRIO_MASK: BT priority value
* @TX_CMD_FLG_BT_PRIO_POS: the position of the BT priority (bit 11 is ignored
* on old firmwares).
* @TX_CMD_FLG_BT_DIS: disable BT priority for this frame
@@ -51,6 +52,7 @@ enum iwl_tx_flags {
TX_CMD_FLG_HT_NDPA = BIT(9),
TX_CMD_FLG_CSI_FDBK2HOST = BIT(10),
TX_CMD_FLG_BT_PRIO_POS = 11,
+ TX_CMD_FLG_BT_PRIO_MASK = BIT(11) | BIT(12),
TX_CMD_FLG_BT_DIS = BIT(12),
TX_CMD_FLG_SEQ_CTL = BIT(13),
TX_CMD_FLG_MORE_FRAG = BIT(14),
@@ -177,7 +179,7 @@ enum iwl_tx_offload_assist_flags_pos {
* ( TX_CMD = 0x1c )
* @len: in bytes of the payload, see below for details
* @offload_assist: TX offload configuration
- * @tx_flags: combination of TX_CMD_FLG_*
+ * @tx_flags: combination of TX_CMD_FLG_*, see &enum iwl_tx_flags
* @scratch: scratch buffer used by the device
* @rate_n_flags: rate for *all* Tx attempts, if TX_CMD_FLG_STA_RATE_MSK is
* cleared. Combination of RATE_MCS_*