@@ -19,6 +19,9 @@ Optional properties:
register within the syscon region
- ti,raminit-start-bit : Bit posistion of START bit in the RAMINIT register
- ti,raminit-done-bit : Bit position of DONE bit in the RAMINIT register
+- ti,raminit-pulse : Property must exist if START pulse is needed for RAMINIT
+ sequence i.e. START bit will be set and cleared before
+ checking for DONE bit.
Note: "ti,hwmods" field is used to fetch the base address and irq
resources from TI, omap hwmod data base during device registration.
@@ -175,6 +175,7 @@ struct c_can_raminit {
unsigned int reg; /* register index within syscon */
u8 start_bit; /* START bit position in raminit reg. */
u8 done_bit; /* DONE bit position in raminit reg. */
+ bool needs_pulse; /* If set, sets and clears START bit (pulse) */
};
/* c_can private data structure */
@@ -120,6 +120,12 @@ static void c_can_hw_raminit_syscon(const struct c_can_priv *priv, bool enable)
ctrl |= 1 << raminit->start_bit;
regmap_write(raminit->syscon, raminit->reg, ctrl);
+ /* clear START bit if start pulse is needed */
+ if (raminit->needs_pulse) {
+ ctrl &= ~(1 << raminit->start_bit);
+ regmap_write(raminit->syscon, raminit->reg, ctrl);
+ }
+
ctrl |= 1 << raminit->done_bit;
c_can_hw_raminit_wait_syscon(priv, mask, ctrl);
}
@@ -340,6 +346,8 @@ static int c_can_plat_probe(struct platform_device *pdev)
}
priv->raminit_sys.done_bit = val;
+ priv->raminit_sys.needs_pulse = of_property_read_bool(np,
+ "ti,raminit-pulse");
priv->raminit = c_can_hw_raminit_syscon;
break;
default:
Some SoCs e.g. (TI DRA7xx) need a START pulse to start the RAMINIT sequence i.e. START bit must be set and cleared before checking for the DONE bit status. Add a new DT property "raminit-pulse" to specify if this mechanism must be used for RAMINIT. Signed-off-by: Roger Quadros <rogerq@ti.com> --- Documentation/devicetree/bindings/net/can/c_can.txt | 3 +++ drivers/net/can/c_can/c_can.h | 1 + drivers/net/can/c_can/c_can_platform.c | 8 ++++++++ 3 files changed, 12 insertions(+)